Korg HDR-TRI manual Mix Audio Track, 6f EQ Equalizer, 6g Send1/Send2 127, 6h Pan Panpot

Sequencer P1

1–6: Mix Audio Track 1–4

Here you can make basic settings for recording audio tracks, and make mixer event settings for each track. Mixer events are recorded according to the record- ing method selected in “1–7: Preference,” so you will need to set those parame- ters as well. Editing of mixer events can be performed in “5–3: Audio Track Edit.”

For details on the basic settings for recording an audio track, refer to “1–5: Audio Track Rec.”

Page Menu

Information for the selected audio track

1–6f

1–6D

1–6g

1–6E

1–6h

1–6i

1–6j

1–6f: EQ (Equalizer)

This adjusts the tone of the audio signal that is output from the 1/L/MONO and 2/R output jacks (and the S/P DIF output).

Depending on the selection in “1–6j: Mix Audio Track Mode,” it may not be pos-

sible to modify this parameter. Refer also to “1–6j: Mix Audio Track Mode.”

H (High EQ) [–15...0...+15]

Adjusts the level of the high frequency range (Fc= 10 kHz) of the audio track playback.

L (Low EQ) [–15...0...+15]

Adjusts the level of the low frequency range (Fc= 100 Hz) of the audio track playback.

1–6g: Send1/Send2 [0...127]

Adjusts the send levels to the master effects (left is Send 1, right is Send 2). Depending on the selection in “1–6j: Mix Audio Track Mode,” it may not be pos- sible to modify this parameter. Refer also to “1–6j: Mix Audio Track Mode.”

1–6h: Pan (Panpot) [OFF, L000...C064...R127]

Specifies the panning to the 1/L/MONO and 2/R output jacks (and the S/P DIF output).

With a setting of OFF, there will be no output to the 1/L/MONO and 2/R out- put jacks (or the S/P DIF output).

Depending on the selection in “1–6j: Mix Audio Track Mode,” it may not be pos-

sible to modify this parameter. Refer also to “1–6j: Mix Audio Track Mode.”

26