Radio Shack 32-2057 quick start Basics Presetting audio input sources

Page 10

The Basics

presetting audio input sources

Before mixing your audio sources (devices connected to LINE 1, PHONO 1, PHONO 2, LINE 2, LINE 3, LINE 4), you must set their input signal level to each channel input (CH1, CH2, CH3). You do not have to mix every connected input source.

1.To preset the PHONO 1 input source, set PHONO 1/LINE 1 to PHONO 1.

2.Play the selected input source.

3.Adjust the volume on your headphones or receiver to a comfortable listening level.

4.Slowly adjust CH1 until you get a reading of up to 0 on the mixer’s LED meters.

5.Stop playback of the selected input source.

6.Repeat steps 2-5 to preset LINE 1 to CH 1, PHONO 2 and LINE 2 to CH 2, and LINE 3 and LINE 4 to CH 3.

The mixer’s LED meters show total stereo output level. For best results, input signal levels should be set so the meters read 0db or less.

PHONO 1/LINE 1

PHONO 2/LINE 2

LINE 3/LINE 4

CH 1

CH 2

CH 3

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents What’s included Channel Stereo Sound MixerContents Important Safety Instructions Basics Basics Setting up your mixer Connecting outputsBasics Connecting inputs Connecting powerBasics Connecting a lamp and headphones Listening safelyUsing your mixer Presetting input signal levelsBasics Presetting audio input sources Presetting the microphone Set OFF/ON/TALKOVER to OFFBeyond the Basics Sound check Beyond the Basics Mixing your inputsPlaying an input source Switching to a second input source Beyond the Basics Monitoring a second input sourceUsing a microphone Using talkoverUsing the seven band equalizer Left ChannelFrequently asked questions Service and repair Replacing the fuse CareSpecifications Input Sensitivity/ImpedanceAccessories Limited one-year warranty
Top Page Image Contents