Radio Shack 32-2057 quick start Using your mixer, Presetting input signal levels

Page 9

The Basics

using your mixer

1.Set your output source’s volume to minimum and turn it on.

2.Press POWER to turn on the mixer.

3.Turn on the audio input sources you want to mix.

4.Preset the input signal levels and mix your audio input sources. Refer to the next two sections for details.

5.When you are finished, turn off all connected audio sources (amplifiers, tape decks, and so on), and press POWER to turn off the mixer.

presetting input signal levels

To avoid overdriving a channel or prematurely mixing an audio input source, adjust your mixer to these settings:

CH 1, CH 2, and

MIC TREBLE and MIC BASS set to 0.

CH 3 set to 0.

CUE LEVEL set to 0.

POWER

ASSIGN A and ASSIGN B set to OFF.

MASTER set to about 5.

For monaural output, set MONO/STEREO to MONO.

For stereo output, set MONO/STEREO to STEREO.

9

Image 9

Contents Channel Stereo Sound Mixer What’s includedContents Important Safety Instructions Basics Basics Connecting outputs Setting up your mixerConnecting power Basics Connecting inputsListening safely Basics Connecting a lamp and headphonesPresetting input signal levels Using your mixerBasics Presetting audio input sources Set OFF/ON/TALKOVER to OFF Presetting the microphoneBeyond the Basics Sound check Mixing your inputs Beyond the BasicsPlaying an input source Beyond the Basics Monitoring a second input source Switching to a second input sourceUsing talkover Using a microphoneLeft Channel Using the seven band equalizerFrequently asked questions Care Service and repair Replacing the fuseInput Sensitivity/Impedance SpeciﬁcationsLimited one-year warranty Accessories