Radio Shack 32-2057 quick start Presetting the microphone, Set OFF/ON/TALKOVER to OFF

Page 11

The Basics

Notes:

•Write down the CH setting for each audio source. Then, when you want to mix that source, you can adjust its volume to that setting.

•If it was necessary to set CH 1 to maximum to get a reading of 0 or less on the LED meter, slide CH 1 down to about 8 and adjust MASTER upward until you get a reading of 0 on both LED meters.

presetting the microphone

1.Turn on your microphone.

2.Set OFF/ON/TALKOVER to ON.

3.While talking, adjust DJ MIC until you get a signal reading of up to 0 on both LED meters.

4.Set OFF/ON/TALKOVER to OFF.

MIC — connect a microphone with an XLR plug here

OFF/ON/TALKOVER

DJ MIC — adjusts volume of the microphone connected to the MIC jack.

MASTER —adjusts overall volume of sources connected to DJ MIC, CH1, CH2, and CH3.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Channel Stereo Sound Mixer What’s includedContents Important Safety Instructions Basics Basics Connecting outputs Setting up your mixerConnecting power Basics Connecting inputsListening safely Basics Connecting a lamp and headphonesPresetting input signal levels Using your mixerBasics Presetting audio input sources Set OFF/ON/TALKOVER to OFF Presetting the microphoneBeyond the Basics Sound check Playing an input source Mixing your inputsBeyond the Basics Beyond the Basics Monitoring a second input source Switching to a second input sourceUsing talkover Using a microphoneLeft Channel Using the seven band equalizerFrequently asked questions Care Service and repair Replacing the fuseInput Sensitivity/Impedance SpecificationsLimited one-year warranty Accessories
Top Page Image Contents