Starting the scan and storing the scan result
Before starting the scan, switch all transmitters of your system off, since channels used by
Select the “SCAN” menu.
Select “START” and confirm your selection by pressing the SET button. After the scan is completed, the number of free channels is displayed. Pressing the SET button once more will store the scan result and lock all channels that are used or subject to interference.
Releasing locked channels
Select the “SCAN” menu.
Select “CLEAR” and confirm your selection by pressing the SET button. All channels in this channel bank can now be selected again.
Multi-channel operation
For
Before putting the transmission links into operation, we recommend performing an auto scan.
Select a channel bank on a receiver.
Scan this channel bank for free channels. If not enough free channels are available in the selected channel bank, repeat the scan with another channel bank.
Apply the scan result to all other transmitters and receivers.
Adjusting the squelch threshold (receiver only)
SQELCH
The receiver is equipped with a squelch that can be adjusted via the “SQELCH” menu. The squelch eliminates annoying noise when the transmitter is switched off. It also suppresses sudden noise when there is no longer sufficient transmitter power received by the receiver.
Note:
Before adjusting the squelch threshold to a different setting, use the volume control to set the volume for the connected headphones to the minimum.
There are three possible squelch settings:
y LO | = | low |
y MID | = | middle |
y HI | = | high |
Selecting the setting “LO” reduces the squelch threshold, selecting the setting “HI” increases the squelch threshold. Adjust the squelch threshold – with the transmitter switched off – to the lowest possible setting that suppresses hissing noise.
63