| Volume Amplification |
| Voice path volume adjustment. |
|
|
|
| ||
|
|
| • Rx is a gain level for signals transmitted by FXS |
|
|
|
| • Tx is a gain level for signals received by FXS. |
|
|
|
| Default = 0dB for both parameters. Loudest volume: +6dB Lowest volume: |
|
|
|
| User can adjust volume of call on either end using the Rx Gain Level parameter and the Tx |
|
|
|
| Gain Level parameter located on the FXS Port Configuration page. |
|
|
|
| If call volume is too low when using the FXS port, adjust volume using the Rx Gain Level |
|
|
|
| parameter under the FXS Port Configuration page. |
|
|
|
| If voice volume is too low at the other end, user may increase the far end volume using |
|
|
|
| the Tx Gain Level parameter under the FXS Port Configuration page. |
|
|
|
|
|
|
|
|
|
|
|
| Caller ID Scheme |
| Default is Bellcore. |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| Disable FXS Caller ID |
| Default is No. If set to Yes Caller ID will not be displayed in the analog phone connected |
|
|
|
| ||
|
|
| to the FXS port. |
|
|
|
|
|
|
|
|
|
|
|
| Enable FXS Call Waiting |
| Default is Yes. If set to No Call Waiting caller ID will not be provided to analog phone |
|
|
|
| ||
| Caller ID |
| connected to the FXS port. |
|
|
|
|
|
|
|
|
|
|
|
| Distinctive Ring Tone |
|
|
|
|
| This function lets you configure ring tone cadence preferences. |
| |
|
|
| Using these settings, user can configure tone frequencies according to user preference. |
|
|
|
| By default, the tones are set to North American frequencies. Frequencies should be |
|
|
|
| configured with known values to avoid uncomfortable high pitch sounds. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| FXS Ring Tone |
|
|
|
|
| This feature allows users to configure different ring tones for audio call/video call |
| |
|
|
| for different accounts. |
|
|
|
|
|
|
|
|
|
|
|
SAVING THE CONFIGURATION CHANGES
After the user makes a change to the configuration, press the “Update” button in the Configuration Menu. The web browser will then display a message window to confirm saved changes.
Grandstream recommends reboot or power cycle the IP phone after saving changes.
REBOOTING THE PHONE REMOTELY
Press the “Reboot” button at the bottom of the configuration menu to reboot the phone remotely. The web browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in again.
Grandstream Networks, Inc. | GXV300x User Manual | Page 38 of 54 |
| Firmware 1.2.3.7 | Updated: 12/2010 |