OWNER’S MANUAL
CAST IRON STOVE AND
Continued |
Gas Valve |
Equipment | Propane/ | |
LP Supply | ||
Shutoff | ||
Tank | ||
Valve | ||
|
INSTALLING OPTIONAL WALL MOUNT SWITCH GWMS2
1.Connect one terminal of 25 ft. wire for the wall switch to the TPTH terminal on the valve. Connect remaining wire terminal to the TH terminal on the valve. Make sure that the wire termi- nals are in the positions on the unit as pictured in Figure 34. If wires are not connected as shown, the switch will not work.
2.Route the 25 ft. wire through openings provided on the sides of the burner sys- tem to a convenient location to mount your switch.
3.Connect one bare wire end to each of the terminals of the GWMS2 wall switch.
4.Install the wall switch and cover in the wall.
Figure 32 - Checking Gas Joints for Propane/LP Gas Burner System
Equipment |
Shutoff |
Valve |
Gas Meter |
Gas Valve |
Figure 33 - Checking Gas Joints for Natural Gas Burner System
To Control
Switch or
Optional
Accessory
Figure 34 - Control Valve Terminals
INSTALLING OPTIONAL WALL MOUNTED THERMOSTAT - GWMT1
WARNING: Installation must be done by a qualified installer familiar with low voltage wiring procedures.
WARNING: Do not connect this thermostat to any electrical source! Electrical shock and/or fire hazard will occur.
1.Open lower door panel. The valve is attached to the underside of the burner system assembly.
2.Disconnect from the valve the wires running from the ON/OFF switch.
Continued
106828 | 15 | For more information, visit www.desatech.com |