OWNER’S MANUAL
CAST IRON STOVE AND
Continued
Installing 9-Volt Battery in Hand- Held Remote Control Unit
1.Remove battery cover on back of re- mote control unit
2.Attach terminal wires to a
3.Replace battery cover onto remote con- trol unit.
| Battery | Remote | |
| Control Unit | ||
Terminal | Cover | ||
| |||
|
| ||
Wires |
|
| |
|
| ||
Battery |
|
|
Battery Housing
Figure 39 - Installing Battery in Hand- Held Remote Control Unit (GHRC Only)
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install logs, lava rock, and ember material. To remove glass door, you must first remove the front panel on stove body.
CAUTION: Do not operate this burner system with a broken glass door panel or without the glass door panel securely in place. For replacement part in- formation see Replacement Parts, page 26.
1.Remove 2 bolts from bottom of stove (if still installed) and one from the top of stove to remove front panel (see Fig- ure 41).
2.Remove the screws from the 2 tabs at the top of the glass door while holding door securely keeping it from falling forward (see Figure 42).
3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 42).
4.To replace glass door, follow the above instructions in reverse.
Bolt
Bolt
Stove Front Panel
Figure 41 - Removing Front Panel from Stove
Screw
Glass
Door
Terminal
Wires
Remote Control Unit
Figure 42 - Removing Glass Door from Burner System
Battery Housing | Battery |
| Cover |
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit (GHRCTA Only)
Continued
106828 | 17 | For more information, visit www.desatech.com |