Vita-Mix XTG012 owner manual Nstructions

Page 14

Instructions

How to operate your Blending Station® MP using the six Pre-Set Programmed Buttons.

The following is the basic MP settings of the six PRE-SET buttons (your machine’s PRE-SET buttons may differ due to program revisions or if your Blending Station MP was programmed specifically for your business).

Button 1: (:13) Blends thin drinks with just juice and ice. Button 1 will ramp the blending speed to medium high for 13 seconds.

Button 2: (:18) Blends light coffee drinks. Button 2 will ramp the blending speed to high for 18 seconds.

Button 3: (:20) Creates a specialty drink with a thick viscosity. Button 3 will ramp the blending speed to high for 20 seconds.

Button 4: (:15) This cycle is good for ice cream and regular coffee drinks. Button 4 increases to medium speed for 5 seconds and then ramps up slowly to high for 10 seconds.

Button 5: (:20) Blend a regular smoothie on high. Button 5 increases to medium speed for 10 seconds and then ramps up slowly to high for 10 seconds.

Button 6: (:25) Blend thick frozen fruits & hard ingredients for a thick but consistent smoothie. Button 6 increases to medium speed for 10 seconds and then ramps up slowly to high for 15 seconds.

1.Place liquids and soft foods in the machine’s container first, solid items and ice last. Prepare food by cutting or breaking into 1-3 inch (3-8 cm) pieces. Frozen fruit, especially, should be as small as practical. Thawed or partially thawed fruit is recommended. We recommend PROGRAMMED button 5 or 6 for heavy-duty blending.

2.Set the container on the motor base by aligning it over the centering pad anchored to the base. (Motor must be completely stopped before positioning container.) Containers are not to be used for hard, dry materials. Avoid running the Blending Station MP with container empty.

3.Always use a lid when blending. If blending hot ingredients, the lid must be securely in place.

14

Image 14
Contents Blending Station MP Important Safeguards Figure a Speed Control Ontrol PanelBlending Station MP High/Low PulseNORM, WARM, HOT, a usage count and a total. Cannot be clearedTurn the machine on Turn the machine on Remove the container from the machineCustom One-Piece Lid optional Id AssemblyTwo-Part Lid Cover with Removable Hinge DesignBack Cover Push until back of cover is seated against the Motor BaseElectrical requirements Do not strike the blender when removing from the counterPreparing the counter area VAC 50/60 Hz 15 AmpsBlending Station dimensions Gasket Installation Instructions Counter GasketLending Tips Never start the motor before the container is in placeNstructions PRE-SET Program Remove the container, pour, garnish and serve the drinkUntil the desired speed Desired speedDo not force. Do not attempt to disassemble blade assembly Retainer Nut Removal#15569 Arts ListItem# Part #15567#1159 #15574 #15575 Are and Cleaning Care NoteLid Motor BaseControl Panel Cover DoorDo not soak the blade agitator assembly ContainerBlending Station MP On-Counter Power RequirementsPecifications Blending Station MP In-CounterSolution #2 Top nine problems you can fix on your ownProblem Solution #1 Solution #3Solution #4 Cooling the motorLimited Warranty ArrantyErvice Contract Foodservice Division Usher Road, Cleveland, Ohio 44138-2103 USA