B lade Agitator Assembly
Blade Agitator Assembly. The blade is sharp, use caution when handling. When inserting the blade assembly through the container bottom, grip the blades with a soft cloth, align the flat sides of the blade assembly with the flat sides of the container. Place the retainer nut back on the inserted blade assembly and tighten clockwise.
Do not force. Do not attempt to disassemble blade assembly.
Drive Spline. Mates with drive socket on the motor base
to turn the blade. NOTE: Removing and replacing your container while the coupling is still rotating will strip the drive spline “teeth.” (This part is NOT removable.)
Retainer Nut. Must be snug. Use the available retainer nut wrench for best results. (Refer to the diagram below to remove or replace.)
Never use a blade assembly with loose, damaged or knicked components.
Retainer Nut Removal
•The retainer nut is easily removed using the Retainer Nut Wrench. To order a Retainer Nut Wrench please call your
•To remove, turn the container upside. Using the Retainer Nut Wrench turn the wrench counter- clockwise to loosen the nut. Once loosened, remove by hand.
•To replace, position retainer nut on top of blade assembly and hand tighten. Then, using the Retainer Nut Wrench, tighten clockwise until it stops. If it is not tight enough, you will notice increased container noise.
Retainer Nut Wrench
17