Vita-Mix XTG012 owner manual Figure a

Page 3

13.Always operate with the lid in place.

14.WARNING: When processing hot liquids:

•The two-part latching lid must be securely in place. This allows steam to escape naturally and will prevent the lid from coming off when the machine is turned on.

•Use caution with hot liquids. Spraying from under the lid plug can occur or escaping steam may cause scalding.

•Do not process hot liquids with the non-latching lid.

15.Display window area will scratch when contacted with a scouring pad or sharp object. Use a soft cloth to wipe the control panel area clean.

16.The Blending Station® MP cannot be cleaned with a water jet.

17.Installation for a 120 VAC unit requires you to have at least one 20 amp outlet per machine, available within six feet of the Blending Station MP. 220 VAC and 100 VAC units require a dedicated line. Consult an electrician for proper electrical needs.

SAVE THESE INSTRUCTIONS

Enjoy the safety of this grounded appliance. The Blending Station MP

U.S. power cord comes equipped with a three-prong (grounding) plug which mates with a standard three-prong wall outlet (Figure A). This cord will vary for countries outside the United States.

Adapters (Figure B) are available for two-prong outlets. Do not cut or remove the third (ground) prong from the plug or power cord.

Consult your electrician if you are not sure if the wall outlet is grounded through the building wiring. With a properly grounded two-prong wall outlet, ground the Blending Station MP by attaching the tab on the adapter to the wall outlet cover by means of the screw in the center of the cover (Figure B).

THREE PRONG

ADAPTERS ARE

NOT TO BE USED

IN CANADA.

Figure A

Figure B

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Blending Station MP Important Safeguards Figure a High/Low Pulse Ontrol PanelBlending Station MP Speed ControlCannot be cleared NORM, WARM, HOT, a usage count and a total.Turn the machine on Remove the container from the machine Turn the machine onCustom Cover with Removable Hinge Design Id AssemblyTwo-Part Lid One-Piece Lid optionalPush until back of cover is seated against the Motor Base Back CoverVAC 50/60 Hz 15 Amps Do not strike the blender when removing from the counterPreparing the counter area Electrical requirementsBlending Station dimensions Counter Gasket Gasket Installation InstructionsNever start the motor before the container is in place Lending TipsNstructions Remove the container, pour, garnish and serve the drink PRE-SET ProgramDesired speed Until the desired speedRetainer Nut Removal Do not force. Do not attempt to disassemble blade assembly#15567 Arts ListItem# Part #15569#1159 #15574 #15575 Care Note Are and CleaningCover Door Motor BaseControl Panel LidContainer Do not soak the blade agitator assemblyBlending Station MP In-Counter Power RequirementsPecifications Blending Station MP On-CounterSolution #3 Top nine problems you can fix on your ownProblem Solution #1 Solution #2Cooling the motor Solution #4Arranty Limited WarrantyErvice Contract Usher Road, Cleveland, Ohio 44138-2103 USA Foodservice Division
Top Page Image Contents