Kenmore 970-5984 manual Setting Oven Controls, Setting Timer, Setting Clock, Add I Minute

Page 12

Setting Oven Controls

Setting Clock

When the appliance is first powered up, 12:00 will flash in the display (See Fig. 1). The time of day must first be set before operating the oven.

Fig. ]

Example; to set the clock to 1:30:

I. Press (_ key pad.

2.Enter 3 0 using numeric key pads.

3.Press START -

Important note:

The dock cannot be changed when a Cook Time or Delay Start feature is active.

Setting Timer

The minute timer allows you to track your cooking times without interferring with the cooking process. The timer may be set from ] minute up to ]] hours and 59 minutes.

Example; to set the timer for 5 minutes:

1.Press Timer Set/Off key pad.

2.Enter 5 using numeric key pad.

3.Press STARTkey pad to start timer.

To cancel the timer when active press Timer Set/Off key pad again.

Important notes:

"The timer does not start or stop the cooking process. It

serves as an extra minute timer in the kitchen that will beep when the set time has run out. The timer may be used alone or while using any of the other oven functions.

The timer will display hours and minutes until 1 hour remains. When less than 1 hour remains, the display will count down in minutes and seconds. Once the timer has less than 1 minute remaining only seconds will display.

When the timer is active during a cooking process, the minute timer will show in the display. To view the information of any other active oven function, press the key pad once for the other function to view the status.

Add I Minute

Use the Add 1 Minute to set additional minutes to the timer. Each press of the key pad will add 1 additional minute. If Add 1 Minute key pad is pressed when the timer is not

active, the timer will activate and begin counting down from 1 minute.

Example; to add 2 minutes to the timer:

Press Add I Minute key pad twice.

Setting 12 or 24 hour display mode

The clock display mode allows you to choose between 12 or 24 hr modes. The factory pre-set clock display mode is 12 hours.

Example; to set 12 or 24 hour display mode:

1.Press and hold _ key pad for 6 seconds.

2.Press Flex Clean key pad to toggle between 12 hour (Fig. 2) or 24 hour (Fig. 3) display modes.

3.Press STARTtO accept choice.

Fig. 2

Fig. 3

Changing between continuous bake setting or

12-Hour Energy Saving feature

The oven control has a factory preset built-in 12 Hour Energy Saving feature that will turn off the oven if the oven is left on for more than 12 hours. The control may be programmed to override this feature to continuously bake.

Example; to change between continuous bake or 12-Hour Energy Saving feature:

1.Press and hold Timer Set/Off key pad for 6 seconds.

2.Press Flex Clean to toggle between 12 Hour Energy Saving (Fig. 4) or continuous bake (Fig. 5) feature.

3.Press sTARto accept choice.

Fig. 4

Fig. 5

12

Image 12
Contents Ienmore Ienrnore Limited Warranty ContentsInstall anti-tip device packed with Save these instructions for future referenceIrnportant Safety Instructions Save these instructions for future referenceProtective Liners = do not USE IgniteSave these instructions for future reference Safety Instructions RnportantProduct Record Serial Plate Location 970Before Setting Oven Contrds Removing, replacing and arranging racksTypes of oven racks Air circulation in the ovenUsing Proper Cookware ControlsSurface MaterialBefore Setting Surface Controls Elernent On indicator lightsAbout the surface elements Home CanningSetting Surface Controls Surface element settingsControl settings Oven Control FunctionsOven control keypads Minimum & maximumSetting Oven Controls Setting TimerSetting Clock Setting 12 or 24 hour display modeChanging oven temperature display Setting Oven LockoutSetting silent or audible control mode To cancel the oven lockout featureSetting Preheat Setting BakeExample set oven for Preheat to 450F Setting Cook Time Setting Delay StartWhen the programmed cook time runs out Cony Bake some models Convection Bake some models Suggestions for Convection bakingCony Roast some models InsideSetting Oven Controk BroilSlow Cook Warm & Hold TM Recipe RecallAdjusting Oven Temperature Recipe Recaff cantdOperating oven light Electrical outlet and circuit protectionSabbath Feature for use on the Jewish Sabbath & Holidays Press Stop Flex Clean Read before starting Flex CleanSelling Flex Clean Example to set Flex Clean to start immediatelyDelayed Start Flex Clean When Flex Clean is finishedIf it becomes necessary to stop Flex Clean when active Care Cleaning Care & Cleaning General cleaningAluminum foil and utensils Cleaning drip bowls Surface elements and drip bowlsTo remove the surface elements and drip bowls Never immerse a surface element in waterWire Raising and lowering the cooktop some modelsReplacing oven light some models Electrical outlet and circuit protection On some modelsRemoving and replacing the lift-off oven door Special door care instructionsTo remove oven door Before You Call . Solutions to common problems Problem SolutionIf you Is tooBefore You Call * Solutions to common problems ProblemProblemSolution Page Protection Agreements