Craftsman 917.28945 owner manual Battery, Engine Fuel System, Engine OIL, Cylinders, Other

Page 30

Immediately prepare your tractor for storage at the end of the season or if the tractor will

t be used for 30 days or more°

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark.

Allow the engine to cool before storing in any enclosure_

TRACTOR

Remove mower from tractor for winter storage, When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc° Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING"

in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened° Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery

may require recharging.

,To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in

the Maintenance section of this manual).

,After cleaning, leave cables disconnected

and place cables where they cannot come in contact with batter,/terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or

methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

°Empty the fueltank by starting the engine and letting it run until the fuel lines and

carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of

fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not

empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm.) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual)_

CYLINDER(S)

1.Remove spark plug(s)_

2.Pourone ounce ofoil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

,Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

,If possible, store your tractor indoors and

cover itto give protection from dust and dirt.

Cover your tractor with a suitable protec- tive cover that does not retain moisture.

Do not use plastic_ Plastic cannot breathe which allows condensation to form and

will cause your tractor to rusL

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

3O

Image 30
Contents RRFT$1ViRN Craftsman Full Warranty TWO Years on Riding Equipment General Operation 11, Children ServiceSlope Operation IV, TowingGeneral Service Customer Responsibilities Repair ProtectionMower Front Wheel KeysUnpack Carton To Check BatteryTo Remove Tractor from Carton SET Parking Brake Lever and Lower Attachment Lift LeverTurn Steering Wheel Left and Position Mower Assemble Front Gauge Wheel To Front of MowerSlide Mower Under Tractor ANTI-SWAY BAR S Attach Mower Side Suspension Arms a to ChassisAttach Rear Lift Links C Attach Front Link Install Belt on Engine Clutch Pulley MMower Drive Belt Installation Replace Mower Blade Drive BeltCheck Deck Levelness ChecklistCheck Tire Pressure Check for Proper Position ALL BeltsHOT Surfaces indicates a hazard which Know Your Tractor To USE Throttle Control D HOW to USE Your TractorTo SET Parking Brake StoppingTo Move Forward and Backward To Adjust Mower Cutting HeightTo Adjust Gauge Wheels To Operate MowerTowing Carts and Other Attach To Operate on HillsTo Transport MentsADD Gasoline Reserve Fuel Valve OperationTo Start Engine Mowing Tips Maintenance ScheduleGeneral Recommendations Battery Engine Lubrication Transaxle CoolingBelts AIR FilterIN-LINEFUEL Filter MufflerOr missing washout Deck Washout PortWarhing Fitting could expose youTo Install Mower To Remove MowerFRONT-TO-BACK Adjustment Visual SIDE-TO-SIDE AdjustmentPrecision SIDE-TO-SIDE Adjustment To Level MowerTo Replace Mower Drive Belt To Replace Motion Drive BeltTo Remove Wheel for Repairs TeryInterlocks and Relays Replacing BatteryTo Remove Hood & Grill Assembly To Replace Headlight BulbEngine OIL BatteryEngine Fuel System CylindersWill not start Engine will notCause ProblemEngine clicks but will not start Loss of power CorrectionIproblem Cause Correction Battery will not Charge Loss of drive Engine dies when tractor is shiftedCause Correction Rl m Sears, Roebuck and Co., Hoffman Estates, IL Funcionamiento General III, Niiios IV. RemolqueOperaciones DE Servicio Generales Page Especificaciones DEL Producto Acuerdos DE Proteccion Para LA ReparacionRueda delantera de la segadore Tubo de desageVerifique LA BATERiA Herramientas Necesarias Para EL MontajeAntes DE Remover EL Tractor DE LA Corredera Ajuste EL AsientoMotor Deslice LA Cortadora DE Cesped Debajo DEL TractorEN EL Chasis SI LA TIENE, Instale LA Barra Antibalanceo SUbicaci6n TAM1ENTO Traseros CInstale LA Correa EN LA Polea DEL Embrague DEL Motor M Reemplazar LA Correa DE LA CuchillaConjunto Revision DE LA Presion DE LAS LlantasRevision DE LA NIVELAClON DEL Revision DE LA Posicion Adecuada@@@@ Familiaricese CON SU Tractor SU TractorDisengaged MientoDE LA Aceler Para Usar EL Control DE ESTRANGULACI6N NPara Ajustar LAS Ruedas CALIBRA- Doras Para Moverse Hacia Adelante YHACtA Atras Para Operar LA SegadoraFuncionamiento ATR/S Remolque DE Carretillas O Otros AccesoriosMECAt-ISMO DE Aviso DE SERVIClO Para Hacer Arrancar EL Motor Agregue GasolinaPara Operar DE LA Valvula DE Gasolina DE Reserva Arranque CON Tiem Poten Plado 50/I 0 Y MAS¸¸ J Consejos Para SegarRecomendaciones Generales Tabla DE LubricacinRemocion DE LA Cuchilla Motor Lubricacion Enfriamiento DEL TransejeCorreas Para Cambiar EL Aceite DEL MotorBujias Limpieza DE LA Rejilla DE AireDE Enfriamento LimpiezaPuerto DE Lavado DE LA Cubierta Para Desmontar LA Cortadora DE La izquierdaPara Instalar LA Segadora Regulacion DE LA Precision DE Lado a Lado Para Nivelar LA SegadoraRegulacion Visual DE Lado a Lado Ajuste DE Delante a ATR,,SDE Movimiento Montaje DE LA Correa DE LA SegadoraPara Cambiar LA Correa DE Impulsion Desmontaje DE LA CorreaPara Remover LAS Ruedas Para Hacer Reparaciones Bloquee el eje en forma seguraPara Hacer Arrancar EL Motor CON UNA Baterja Baja Para Cambiar LA Bombilla DE LA LUZ Delantera Reemplazar LA BateriaImpresion / Inclinacion DE LAS Ruedas Delanteras Entrecierre Y RelesImportante Es important evitar qua se for BateriaMotor Sistema DE Combustible Aceite DEL MotorIdentificacion DE Problemas Yea la secci6n apropiada en el manual a menosQue est dirigido a un centro de servicio Sears 1DENTIFICACION DE Problemas CausaCosde Prdtda de ImpulsI6nPage Page Page €3 --t Canada HomeBBB.SU4.tOGAR 80O-LE-FOYERMc