TO LEVEL MOWER
Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under
inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1.With al! tires properly inflated and if your lawn appears unevenly cut, determine
which side of mower is cutting lower.
NOTE: As desired, you can raise the low side of mower or lower the high side°
2.Go to side of mower you wish to adjust. 3_ With a 3/4" or adjustable wrench, turn lift link adjustment nut (A) to the left to lower the mower, or, to the right to raise
the mower_
Turn nut rig | Turn nut left |
to raise mower | to Dowermower |
NOTE: Each full turn of adjustment nut will change mower height about 3/16".
4.Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.
PRECISION SIDE-TO-SIDE ADJUSTMENT
1. With alltires properly inflated, park tractor on level ground or driveway.
•(_ CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.
2.Raise mower to its highest position.
3.At both sides of mower, position blade at side and measure the distance (A) from
bottom edge of blade to the ground. The distance should be the same on both sides.
4.if adjustment is necessary, see steps 2
and 3 in Visual Adjustment instructions above.
5o Recheck measurements, adjust if neces- sary until both sides are equal.
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-
To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/6" to 1/2" lower than the rear tip when the mower is in its highest position.
,_ CAUTION: Blades are sharF Protect your hands with gloves and/or wrap blade with heavy cloth.
•Raise mower to highest position.
•Position any blade so the tip is pointing straight forward° Measure distance (B) to the ground at front and rear tip of the blade.
•If front t!p of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.
•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.
•With a 3/4" or adjustable wrench, turn front link adjustment nut (B) clockwise (Itighten) to raise the front of mower, or,
counterclockwise (loosen) to lower the front mower.
Tighten adjust nut | Loosen adjust |
B to raise mower | nut B to lower |
| mower |
Loosen jam nut A first
NOTE: Each full turn of the adjustment nut will change mower height about 1/8".
°Recheck measurements, adjust if neces- sary until front tip of blade is 1/8" to t/2" lower than the rear tip.
°Hold adjustment nut in position with wrench and tighten jam nut securely against ad- justment nut.
26