Craftsman 917.272051 To Start Engine with a Weak Battery, To Adjust Steering Wheel ALIGN- Ment

Page 24

TRANSAXLE GEAR SHIFT LEVER NEUTRAL ADJUSTMENT

The transaxle should be in neutral when

the gear shift lever is in neutral (N) (look gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:

1.Make sure transaxle is in neutral (N), NOTE; When the tractor rear wheels

move freely, the transaxle is in neutral.

2.Loosen adjust_'nent bolt in front of the right rear wheel.

3.Position the gear shift lever in the neutral (N) position.

4, Tighten adjustment bolt securely. NOTE: If additional clearance is needed

to get to adjustment bolt, move mower deck height to the lowest position.

Gearshift Lever

Neutral Lock Gate

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your Iooal parts

dealer. Tire sealant also prevents tire dry rot and corrosion.

Washers

Retainin

Ring

Axle

Cover

I

Square Key

(Rear Wheel Only)

TO START ENGINE WITH A WEAK BATTERY

Adjustment Bolt

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not

horizontal (left to right) when wheels are positioned straight forward, remove steering wheel and reassemble per

instructions in the Assembly section of this manual.

FRONT WHEEL TOE-INJCAMBER

The front wheel toe-in and camber are

not adjustable on your tractor. If damage has occurred to affect the front wheel toe-

in or camber, contact a Sears or other qualified service center.

TO REMOVE WHEEL FOR REPAIRS

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not _ose).

3.Repair tire and reassemble.

NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

4.Replace washers and snap retaining ring securely In axle groove,

5.Replace axle cover.

A_IkCAUTION: Lead-acidbatteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries.

Always wear eye protectionwhen around battedes.

If your battanJ is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE section of this manual).

If "jumper cables" are used for emergency

start',,ng,followthis procedure:

IMPORTANT: Your tractoris equipped with a 12 vo_ negative grounded system. The other vehical must also be a 12 volt negative grounded system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1.Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

2.Connect one end of the BLACK cable

to the NEGATIVE (-) terminal of fully charged battery.

3.Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Icraftsmanj Limited Twoyear Warranty on Craftsman Riding Equipment Parts Limited 90 DAY Warranty on BatterySerious injury or death General OperationWhile on the slope Follow the manufacturers recommen Do notIV. Service Adjust and service as requiredHi. Children Responsible adultSafety is Involved Product Specifications Park PlugRepair Agreement Customer ResponsibilitiesSteering Tools Required for Assembly Remove all accessible loose partsHowto SET Upyourtractor Check Battery Before Removingtractor from Skid Attach Steering WheelInstall Seat Adjust seat before tightening adjustment knobTo Drivetractor OFF Skid Operation section for location al function of controlsInstall Mulcher Plate R N H L Knowyourtractor Your Tractor Howto Useyourtractor To SET Parking Brake StoppingEngine To USE Throttle ControlTo Adjust Gauge Wheels Gauge WheelTo Operate Mower To Stop Mower BladesTowing Carts and Other Attachments Before Startingthe Engine Check Engine OIL LevelADD Gasoline To Start EngineMowingtips Mower should be properly leveled forMulching Mowingtips Maintenance Schedule Lubrication ChartGeneral Recommendations Before Each USETractor Clean AIR Screen Clean AIR INTAKE/COOLING AreasBelts Transaxle CoolingAIR Filter MufflerSpark Plugs Engine OIL FilterCleaning To Install MowerTo Remove Mower Raise attachment lift lever to its highest positionTo Level Mower Housing FRONT-TO-BACK AdjustmentOn level ground or driveway. Make sure JLiftLink Ustrnent NutBelt Installation To Adjust BrakeTo Replace Mower Blade Drive Belt Belt RemovalTo Start Engine with a Weak Battery Transaxle Gear Shift Lever Neutral AdjustmentTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-INJCAMBERReplacing Battery To Remove Hood and Grill AssemblyTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Carburetor AdjustingCable BracketBatfery Engine Fuel SystemEngineoil CylindersTroubleshooting Chart ProblemCause Correction Troubleshooting Chart Problem Cause Troubleshooting Chart Problemcause CorrectionSchematic Tractor - Model NumberElectrical KEY Part NO. NO.DESCRIPTION Tractor - Model Number 917.272051 Chassis and Enclosures Tractor - Model Number Chassis and Enclosures KEY Part DescriptionTractor - Model Number Ground Drive KEY Part DescriptionTractor - Model Number 917.272051 Steering Assembly TRACTOR- Model Number Steering Assembly KEY Part DescriptionTRACTOR-- Model Number Spark ArresterTRACTOR- Model Number Seat Assembly Decals Wheels &TIRESTRACTOR- Model Number Lift Assembly +-j,j+,. l Tractor - Model Number Mower DeckNots Allcomponent dimensions givenin U.S. inches Peerless Transaxle - Model Number 206-545C 778345 @/---L Valve, exhaust Std Blower Housing and Baffles l Blower Housing & Baffles KEY Part Description IGNITION/ELECTRICAL KEY Part DescriptionNot Illustrated AIR INTAKE/FILTRATION KEY Part Description20\ Starting System KEY Part Description OIL PAN/LUBRICATION KEY Part DescriptionEngine Controls KEY Exhaust J Fuel System KEY Part Description Exhaust KEY Part DescriptionPage Page Page Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillGet it fixed, at your home or ours

917.272051 specifications

The Craftsman 917.272051 is a robust and versatile lawn tractor designed to meet the diverse needs of homeowners and landscape enthusiasts. With its powerful engine and user-friendly features, this model stands out in its class, providing a reliable solution for maintaining a pristine lawn.

One of the standout features of the Craftsman 917.272051 is its impressive 20 HP Briggs & Stratton engine. This air-cooled, single-cylinder engine is designed to deliver robust performance, making it easy to tackle a variety of mowing tasks. The engine's reliable starting system ensures minimal downtime, allowing users to efficiently manage their mowing schedule.

The cutting deck of the 917.272051 is another highlight, measuring 42 inches in width. This size strikes a balance between maneuverability and efficiency, enabling users to navigate tight spaces while still covering a generous amount of terrain in one pass. The deck also features a deck wash system, allowing for easy cleaning and maintenance after use, which helps extend its lifespan and maintain optimal performance.

Equipped with a 6-speed transmission, the Craftsman 917.272051 offers users the flexibility to choose the appropriate speed for various mowing conditions. This feature enhances control and allows for a smoother cutting experience, whether tackling overgrown grass or maintaining a manicured lawn.

Another significant aspect of the Craftsman 917.272051 is its comfortable, ergonomic design. The high-back seat provides ample support during extended mowing sessions, reducing fatigue and improving the overall experience. Additionally, the steering wheel is positioned to offer ease of handling, making it accessible even for users with less experience.

Safety features are also a priority in the design of the 917.272051. The tractor includes a built-in safety switch, which automatically disengages the blades when the operator leaves the seat. This feature adds a crucial layer of safety, protecting users from accidents while ensuring the mower functions efficiently.

Overall, the Craftsman 917.272051 lawn tractor combines power, performance, and user-friendly features, making it an excellent choice for homeowners seeking a dependable tool for lawn care. With its durable construction and advanced technologies, this model is equipped to handle the rigors of regular use, ensuring a well-maintained yard season after season.
Top Page Image Contents