Positive Terminal | Negative Terminal |
| Battery |
Positive Terminal | Negative Terminal |
REPLACING BATTERY | |
_CAUTION: | Do not short battery |
terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected first
to prevent sparking from accidental grounding.
1.Lift seat pan to raised position and open battery box door.
2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.
3.Install new battery with terminals in same position as old battery.
4.First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely.
5.Connect BLACK grounding cable to negative
6.Close battery box door.
Battery
Door
Keps_ | :, | Hex |
Nut | Bolt |
Positive (Red) Cable Negative (Black) Cable
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring
diagram in the Repair Parts section,
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL ASSEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood
at sides, tilt toward engine and lift off of tractor.
4.To replace, reverse above procedure.
A
/.Q
_ j Hood
---HeadlightWire
Connector
25