TO START ENGINE WITH A WEAK BATTERY
_CAUTION:
If your battery is too weak to start the
engine, it should be recharged. (See "BATTERY" in the MAINTENANCE
section of this manual).
If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt negative grounded system. The other vehical must also be a 12 volt negative grounded system. Do not use your tractor battery to start other vehicles.
TO ATTACHJUMPER CABLES -
1.Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.
2.Connect one end of the BLACK cable
to the NEGATIVE
3.Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
"Positive" | . | • . |
(*) |
| Negative |
| (.) |
REPLACING BATTERY
terminals by allowing a wrench or any other object to contact both temlinals at
the same time. Before connecting battery, remove metal bracelets, wristwatch
bands, degs, etc.
Positiveterminal must be connected first to prevent sparking from accidental grounding.
1.Lift hood to raised position.
2.Remove terminal guard.
3.Disconnect BLACK battery cabe then RED battery cable and carefully remove battery from tractor.
4.Install new battery with terminals in same position as old battery.
5.Reinstall terminal guard.
6.First connect RED battery cable to positive (+) battery terminal with hex
bolt and keps nut as shown. "[]ghten securely.
7.Connect BLACK grounding cable to negative
8.Close terminal access doors.
9.Close hood.
keps Nut
Terminal |
| |
Acces_ | x Bolt | |
Door | ||
Terminal |
| |
Guarc__Positive | (Red) | |
I | Cable | |
(Black)Cable | ||
_; I/ |
TO REPLACE HEADLIGHT LAMP
ACAUTION: When lit, the halogen lamps get extremely hot. Hold lamp assembly by the holder and do not touch the bulb.
1.Raise hood.
2.Disconnect harness from lamp assembly.
3.Rotate counterclockwise and pull lamp assembly out of the hole in the backside of the gdll.
4.Insert new lamp assembly and rotate clockwise to lock.
5.Reconnect harness to lamp assembly.
6.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged widng may cause your tractorto run poorly,stop running, or prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
plng4n fuse. The fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4. To replace, reverse above procedure:
26