Craftsman 917.27224 manual General Operation, II. Slope Operation

Page 3

IMPORTANT:Thiscuttingmachineiscapableofamputatinghandsand feet and

throwing objects, Failure to observe the following safety instructions could result in serious injury or death.

I. GENERAL OPERATION

Read, understand, and follow all instructionsin the manual and on the machine before starting.

Only allow responsible adults, who are familiar with the instructions,to operate the machine.

Clear the area of objects such as rocks,

toys, Wire, etc., which couldbe picked up and thrown by the blade.

Be sure the area is cleer of other people

before mowing. Stop machine if anyone enters the area.

Never carry passengers.

Do not mow in reverse unless absolutely necessary. Always look down and behind before and while backing.

Be aware of the mower discharge directionand do not point it at anyone. Do not operate the mower withouteither the entire grass catcher or the guard in place.

Slow down before turning.

Never leave a running machine unattended. Always turnoff blades, set

perking brake, stop engine, and remove keys before dismounting.

Turn off blades when not mowing.

Stop engine before removing grass catcher or unclogging chute.

Mow only in daylight or good artificial light.

0o not operate the machine while under the influence of alcohol or drugs.

Watch for trafilc when operatingnear or crossing roadways.

Use extra care when loading or unload- ing the machine into a trailer or truck.

Data indicates that operators, age 60 years and above, are involved in a large percentage of riding mower#elated injuries. These operators should evaluate their ability to operate the riding mower safely enough to protect them- salves and others from serious injury.

Keep machine free of grass, leaves or other debris build-up which can touch hot exhaust / engine parts and bum, Do not allow the mower deck to plow leaves or other debris which can cause build- up to occur. Clean any oil or fuel spillage before operating or storing the machine. Allow machine to cool before

storage.

II. SLOPE OPERATION

SIopee are a ma_orfactor related to toss--of-control and tipover accidents, which can re- suil in severe Injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it.

DO:

Mow up and down dopes, not across.

Remove obstacles such as rocks,tree limbs,etc.

Watch for holes, ruts, or bumps. Uneven terrain could overturn the machine. Ta//

grass can hide obstac/es.

Use slow speed. Choose a low gear so that you will not have to stop or shift while on the slope.

Follow the manufacturer's recommenda- tions for wheel weights or counter-

weights to improve stability.

Use extra care with grass catchers or other attachments. These can change the stabilityof the machine.

Keep all movement on the dopes stow and gradual. Do not make sudden changes in speed or direction.

Avoid sta_ng or stoppingon a slope. If tires lose traction, disengage the blades and proceed slowly straightdown the

slope.

DO NOT:

Do not turn on slopes unless necessary, and then, turn slewiy and gradually downhill, if possible.

Do notmow near drepoffs, ditches,or embankments. The mower coule suddenly turn over If a wheal is over the edge of a cliffor ditch,or if an edge caves _.

DO notmow on wet grass. Reduced tractioncould cause sliding.

Oo net try to stabilizethe machiee by putting your foot on the ground.

Do notuse grass catcher on steep slopes.

Image 3
Contents Icrrftsmrni Assembly WarrantySafety Rules Product SpecificationsII. Slope Operation General OperationIV. Service Never run a machine inside a clo= areaMower blades are sharp and can Cancer and birth defects or other repro- ductive harm IfmachinestopswhilegoinguphillCustomer Responsibilities Product Specifications3ASOLINE 3.5 Gallons Repair AgreementSteering Wheel SeatSlope Sheet To Removetractor from Carton Unpack Carton Tools Required for AssemblyHowto SET Upyourtractor Check Battery Install SeatLower seat into operating position and sit in seat Assemble Gaugewheelsto Mower DeckCenter Iocknuts and tighten securely Be sure belt tension rod is in disen- gaged position Lock Ut B BracketSlide mower under tractor with Lower mower linkage with attachment lift controlCheck Brake System Checktire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsRRN Pedal Hourmeter Indicates hours of operation KnowyourtractorGround Drive To Adjust Mower Cutting HeightHowto Useyourtractor to SET Parking Brake Stopping Mower BladesTo Operate on Hills To Adjust Gauge WheelsTo Operate Mower To Stop Mower BladesADD Gasoline To Start EngineFree.wheellever while the engine is running Engine warm up periodPulled out slightly PurgetransmissionBefore Each USE Lubrication ChartMaintenanceschedule General RecommendationsBlade Care BatteryTires Operator Presence SystemTransaxle Pump Fluid To Clean Battery and TerminalsEngine Lubrication BeltsTo Service Cartridge Clean AIR ScreenClean AIR INTAKE/COOLING Areas To Service PRE-CLEANERTo Remove Mower To Install MowerAssembly section of this manual TractorBoth Front Links Must be Equal Length SIDE-TO-SIDE AdjustmentFRONT-TO-BACK Adjustment Raise mower to its highest positionTo Replace Mower Blade Drive Belt To Adjust BrakeRemove belt from electdc clutch pulley Cover Clutch Posin IdlerFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel ALIGN- MentTransmission REMOVAL/REPLACE- Ment To Replace Motion Drive BeltTo Remove CABLES, Reverse Order To Start Engine with a Weak BatteryReplacing Battery To Attachjumper CablesPreliminary Setting To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorAcceleration Test Final SettingRecheck idle speed. Readjust if necessary Wise 1 tumCylinders To Clean Battery and TermiTractor Engine OILCause Correction Troubleshoongchart ProblemCorrection Troubleshooting ChartProblem CauseOFF CauseSeatswitch TRACTOR-- Model Number SchematicTractor - Model Number Electrical KEY Part Description TRACTOR-- Model Number ElectricalTRACTOR- -MODELNUMBER917.272240 Chassisandenclosures Tractor - Model Number 9t7.272240 Chassis and Enclosures TRACTOR- -MODEL NUM BER Ground Drive 250 TRACTOR- Model Number Ground DriveTRACTOR- -MODEL Number Steering Assembly TRACTOR-- Model Number 917.272240 Steeringassembly TRACTOR- Model Number Engine Tractor - Model Number Engine KEY Part NO. NO. Description TRACTOR- Model Number Seat AssemblyDescription KEY Part TRACTOR- Model Number DecalsTractor - Model Number Liftassembly 37 123935X Plug Hole 38 17066516 Screw 5/16-18 x TRACTOR-- Model Number LiftassemblyTRACTOR- -MODEL Number Mowerdeck 5116-18 x 5/8 Tractor - Model Number MowerdeckOe oo 032 Ift22 KEY Part NO. no Description Descripon Blower Housing and Baffles Ignitionicharging KEY Part Description Starting System I Engine Controls KEY Part Description NO. no Crankshaft J Exhaustj Exhaust Page Page Page Suggested Guide for Sighting Slopes for Safe Operation Part Canada