McCulloch 96041012300, M11577RB instruction manual To Assemble Bagger, Handle insert

			2
TO ASSEMBLE BAGGER
	2	1	3
			11
			11
			12
3
• Feed top bagger frame tube (1) through loop (2) at the top
of bagger fabric (leave loop segments on the ends loose).
			9
4	1
		5
6
• First, align two holes as shown on side of bagger frame
upper weldment (4) with corresponding holes in top bagger			10
frame tube (1).
• Install two 1/4"- 20 x 1.25 carriage bolts (5) and secure with			• Lay bagger cover upside-down (leave protective covering
two 1/4" nuts (6).
			intact).
1			• Slide bagger handle insert (9) into depression on inside of
			bagger cover. Make sure the two tabs at the top lock into
			place with the bagger cover. Teeth at the bottom of the
			bagger handle insert should slide into place in between the
5			teeth on the bagger cover.
		4	• Slide two square nuts (10) into the two square slots at the
			front of the bagger cover and two square nuts into the two
			square slots (one slot on each side) at the rear handle of the
			bagger cover.
		6	• Turn bagger assembly (3) upside-down, lining up holes in the
			frame to holes in the bagger cover, making sure frame upper
			weldment tubing is seated in plastic cradle in the bagger
• Align two holes on opposite of bagger frame upper weldment			handle insert (9).
(4) with corresponding holes in top bagger frame tube (1).			• Install four 1/4” hex bolts (11) (1/4-20 UNC x 1.15) in holes
• Install two 1/4"- 20 x 1.25 carriage bolts (5) and secure with			with four square nuts (10) and tighten until seated.
two 1/4" nuts (6).			• Install two 1/4” screws (12) (1/4-20 UNC x 1.15 gold) in holes
			at center of frame upper weldment.
1		7
7
8

•Install two more carriage bolts (7) rearward on sides of top bagger frame tube, hand tightening nuts (8).

25