Note: In the example, Factory PRESET #3, named "2x3W" has been loaded: Its system configuration is Input A signal assigned to outputs 1, 3 and 5; Input B signal assigned to outputs 2, 4 and 6.
Loading a PRESET, a PRESET Change command is also automatically sent to the serial ports and can be used to automatically load a PRESET with the same number to any other MAXIDRIVE3.4 units connected and enabled (Refer to UTILITY menu - Comm. Setup submenu - PRESET Change RX option).
5.1.2 Store & Naming PRESET
Use this menu to create new PRESETS, i.e. to save all the current system settings.
S t o r e P r e s e t
2 U 2 x 2 W + 2 M A X
To save a PRESET:
Use DIAL to reach the memory area in which the PRESET is to be saved.
Note: In this procedure, the Factory PRESET areas aren't available, since the Factory PRESETS can not be permanently remember that it is possible to load a Factory PRESET, modified. Nevertheless save it in a User PRESET or Card PRESET area, modify it as required and then store it again in the same User or Card area.
Note: Scrolling through the memory areas, the display shows the number, type and name of the PRESETS contained in them; scrolling through the 128 Card memory areas without the Multimedia Memory Card, a warning appears on the display:
S t o r e P r e s e t
3 U O p e r a H a l l 1
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| S | t | o | r | e |
| P | r | e | s | e | t |
|
|
|
|
|
|
|
| 1 | 0 | 1 | C |
|
| N | O |
| C | A | R | D |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Press ENTER. The PRESET Naming page appears, by means of which it s possible to edit the name of the PRESET to be saved.
Note: If you're in one of the 128 memory areas reserved for the Card and you remove the Multimedia Memory Card before pressing ENTER, nothing happens: the display remains unchanged and Store PRESET procedure remains unvaried.
The name of the start PRESET (i.e. of the PRESET currently loaded) is proposed as default. The cursor takes up position on the first of the twelve character spaces available.
P r e s e t N a m i n
2 
2 W + 2 M A X
At this point:
If you decide to accept and confirm the name suggested, press ENTER.
If you want to abort Naming procedure (for example because you've chosen the wrong memory area) and return to Store PRESET procedure, press ESC.
If you want to assign a new name to the PRESET you're storing:
-use the 
and 
keys to position the cursor on the required character
-use DIAL to enter the alphanumeric value wanted
-after finishing, press ENTER.
12