Section 4: Operation
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to store your rotating brush, utility brush, turbo nozzle, and ProjectPro™ nozzles.There is also a hook at the front of the accessory tray to hold your high pressure hose.
1.Store your gun and nozzle extension on the hooks attached to the base and handle, as shown in Figure 13.
Figure 13 — Typical Accessory Tray
2.Place rotating brush through hole on accessory tray on right side of unit (Figure 13).
3.Place utilty brush through hole on accessory tray, as shown in Figure 13.
3.Push turbo nozzle up and into clip on accessory tray until it snaps in, as shown in Figure 13.
4.Hang high pressure hose on hook attached to accessory tray on front of tray, as shown in Figure 13.
How to Use ProjectPro™ Nozzle System
The
CAUTION
A pressure washer produces a high pressure spray which increases risk of injury and damage to unit.
•NEVER exchange ProjectPro™ nozzles without locking the trigger lock on the trigger.
•DO NOT twist ProjectPro™ nozzles while spraying.
Figure 14 — Nozzle Spray Patterns
| Low Pressure |
|
| Black |
|
| Use to apply | |
| detergent | |
| High Pressure |
|
Delicate | General | Max |
40° Yellow | 15° Orange | 0° Red |
1750 PSI | 2200 PSI | 2550 PSI |
2.3 GPM | 2.2 GPM | 2.0 GPM |
Follow these instructions to change ProjectPro™ nozzles:
1.Engage trigger lock on spray gun.
2.Pull back collar on
3.Select desired ProjectPro™ nozzle:
•For delicate rinse (lower pressure and higher flow), for gentle cleaning of cars/trucks, boats, RV’s, patio furniture, lawn equipment, etc., select yellow Delicate ProjectPro™ nozzle (Figure 15).
Figure 15 — Delicate Nozzle
12