Troy-Bilt 20240 manual Maintenance Section, Specifications, General Maintenance Recommendations

SPECIFICATIONS

Max Outlet Pressure . . . . . . . . . . . . . . . . . . . . . 2550 psi Max Flow Rate . . . . . . . . . . 2.3 gallons per minute (gpm) Detergent Use detergent approved for pressure washers

Water Supply . . . . . . . . . . . . . . . . Not to Exceed 100°F

Temperature

Automatic Cool . . . . . . . . . . . . . Will cycle when water

Down Systemreaches 125°-155°FShipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . .75 lbs.

GENERAL MAINTENANCE RECOMMENDATIONS

The pressure washer warranty does not cover items that have been subjected to operator abuse or negligence.To receive full value from the warranty, the operator must maintain the pressure washer as instructed in this manual.

NOTE: Should you have questions about replacing components on your Troy-Bilt pressure washer, please call 1-888-611-6708for assistance.

•Some adjustments will need to be made periodically to properly maintain your pressure washer.

•All maintenance in this manual and the engine operator’s manual should be made at least once each season.

•Once a year you should clean or replace the spark plug, clean or replace the air filter and check the spray gun and nozzle extension assembly for wear.A new spark plug and clean air filter assure proper fuel-air mixture and help your engine run better and last longer. Please refer to your engine operator’s manual for more details.

•If equipped with inflatable tires, keep the air pressure at the value marked on the tire or within 15 and 40 psi.

PRESSURE WASHER

MAINTENANCE

Check and Clean Inlet Screen

Examine the screen on the pump’s water inlet. Clean it if the screen is clogged or replace it if screen is damaged.

Check High Pressure Hose

The high pressure hose can develop leaks from wear, kinking, or abuse. Inspect the hose each time before using it. Check for cuts, leaks, abrasions or bulging of cover, damage or movement of couplings. If any of these conditions exist, replace the hose immediately.

WARNING

The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.

•NEVER repair high pressure hose. Replace it.

•Replacement hose rating MUST exceed maximum pressure rating of unit.

Check Chemical Injection Hose

Examine the filter on the detergent tube and clean if clogged.The tube should fit tightly on the barbed fitting. Examine the tube for leaks or tears. Replace the filter or tube if either is damaged.

Check Gun and Nozzle Extension

Examine the hose connection to the spray gun and make sure it is secure.Test the trigger by pressing it and making sure it “springs back” into place when you release it. Put the trigger lock in the ON position and test the trigger. You should not be able to press the trigger.

Before Each Use

•Check engine oil level.

•Check water inlet screen for damage.

•Check in-line filter for damage.

•Check high pressure hose for leaks.

•Check chemical injection hose and filter for damage.

•Check spray gun and nozzle extension assembly for leaks.

•Rinse out garden hose to flush out debris.

Check In-Line Filter

Refer to Figure 21 and service the in-line filter if it becomes clogged, as follows:

Figure 21 — Clean In-Line Filter

Filter Screen

Nozzle Extension

O-ring