Zenith C-30HDG manual 30HDG Pump Control BOX Components, Pump Control Box Components

C-30HDG PUMP — CONTROL BOX COMPONENTS

Figure 8. Pump Control Box Components

Figure 8 illustrates the location of the major components for the C-30HDG Control Box. The function of each component is described below:

1. Throttle Control Switch – This is a variable speed type control. Holding the control switch to the left increases the engine speed.To place the engine at IDLE speed, hold the control switch to the right and let the engine run for 3-5 minutes.

2. Emergency Stop Button– In the event of an emergency or to shutdown the engine, push RED emergency stop button inward. This will stop the engine. To restart engine, emergency stop button must be released from the stop position. Simply pull back on the emergency stop button to release.

3. Ignition Switch – Insert the ignition key here to start the engine. Turn the key clockwise to the ON position, then continue turning clockwise to the START position and release. To stop the engine turn the key fully counter- clockwise to the STOP position.

4. Remote Control Input Connector – Insert the remote control input cable into this connector.

5. Pumping Control Switch – This 3-position switch controls the pumping of the pump.The left most position is for use with the remote control unit, the center position is for off (prevents pumping), and the right most position is for normal pump operation.

6. Hourmeter– Display's the number of hours the pump has been in use.

8. Hood Open Lamp– When lit (red) indicates that the hood has been raised (open) during pumping operation. This condition will force the engine into idle mode.

7. Check Engine Lamp– When lit (yellow) indicates that an engine error as occured. See Table 7 for a listing of engine diagnostic error codes.

PAGE 24 — MAYCO C-30HDG PUMP — OPERATION AND PARTS MANUAL — REV. #6 (04/02/12)