Zenith C-30HDG manual 30HDG Pump STARTUP/SHUTDOWN Procedures, Remote Control Operation

C-30HDG PUMP — STARTUP/SHUTDOWN PROCEDURES

3.Inserttheignitionkeyintotheignition switch(Figure22),turn the key to the ON position, then to the START position, release the key when the engine starts.

2.On the control box, place the pumping control switch in the REMOTE ON position (Figure 25)

Figure 25. Pumping Control Switch (Remote)

Figure 22. Ignition Switch

4.Let the engine run for 3-5 minutes before putting pump into operational use. Push the choke knob in all the way.

5.Listenforanyabnormalsounds.Ifanymechanicalorelectri- calproblemsexists,STOPtheengineandcorrecttheproblem.

6.To begin pumping concrete. Place the pumping control switch (Figure 23) in the ON position

Figure 23. Pumping Control Switch (ON) System Shut-Down

1.Place the pumping control switch in the OFF position (Figure 21).

2.Let the engine run at idle speed for 3-5 minutes.

3.Turn the ignition key (Figure 22) to the OFF position.

4.Cleanpumpasreferencedinthemaintenancesectionofthis manual.

Remote Control Operation

1.Connect the hand-held remote control cable (Figure 24) to the control box.

3.To begin pumping, place the toggle switch on the hand-held remote unit (Figure 24)in the pump ON position

Radio Remote Control Operation

The MAYCO C30HDG Concrete Pump has a remote control feature (Figure 26) that allows the pump to be radio controlled via a receiver/transmitter technique.

Contact your MAYCO representative for further information regarding radio control pumping capability.

Figure 26. Handheld RadioReceiver/Transmitter

Figure 24. Handheld Remote Control Cable

MAYCO C-30HDG PUMP — OPERATION AND PARTS MANUAL — REV. #6 (04/02/12) — PAGE 37