Yazoo/Kees ZCBI48180 manual To Adjust ANTI-SCALP, Rollers See Figure, To Operate Mower

	OPERATION
FOOT	ANTI-SCALP
	ROLLER
PEDAL
	LIFT
	ARM
HEIGHT
PLATE

FIGURE 5

TO ADJUST ANTI-SCALP

ROLLERS (See Figure 6)

Anti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Anti-scalp rollers then keep the deck in the proper position to help prevent scalping in most terrain conditions.

NOTE: Adjust Anti-scalp rollers with the mower on a flat level surface.

•Adjust the deck to the desired cutting height (see “TO ADJUST DECK CUTTING HEIGHT” in the operation section of this manual).

•Using a 3/4" wrench and a 9/16" wrench, remove the nut and shoulder bolt from the anti-scalp roller.

•Lower the anti-scalp roller to the ground, and raise it up to the next highest hole.

•Replace and tighten the nut and shoulder bolt.

•Be sure to adjust all of the anti-scalp rollers to the same position.

•Be sure to readjust the anti-scalp rollers if the cutting height is changed.

FIGURE 6

TO OPERATE MOWER

Your mower is equipped with an operator presence system. When the engine is running, any attempt by the operator to leave the seat without first setting the park brake will shut off the engine.

•Select desired height of cut.

•Start deck blades by pulling the PTO switch up into the engaged position.

•To stop the deck blades, press down on the PTO Switch into the disengaged position.

WARNING

Do not operate the deck without either the entire grass catcher, mulch kit or discharge chute installed.

TO OPERATE ON HILLS

WARNING

Do not drive up or down hills with slopes greater than 10 degrees. And do not drive across any slopes.

IMPORTANT: THE ANTI-SCALP ROLLERS MUST NOT BE USED FOR GAUGE WHEELS OR THE ROLLER AND DECK MAY BE DAMAGED.

14