Yazoo/Kees ZCBI48180 manual III. Children, III. Service

Page 5

SAFETY RULES

SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS

DO NOT:

Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible.

Do not mow near drop-off, ditches, or embankments. The mower could suddenly turn over if a wheel is over the edge of a cliff or ditch, or if an edge caves in.

Do not mow on wet grass. Reduced trac- tion could cause sliding.

Do not try to stabilize the machine by putting your foot on the ground.

Do not use grass catcher on steep slopes.

III. CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the mowing activity. Never assume that children will remain where you last saw them.

NEVER allow children to operate the machine.

Keep children out of the mowing area and under the watchful care of another respon- sible adult.

Be alert and turn off the machine if children enter the area.

Before and when backing, look behind and down for small children.

Never carry children. They may fall off and be seriously injured or interfere with safe machine operation.

Use extra care when approaching blind corners, shrubs, trees, or other objects that may obscure vision.

III.SERVICE

The operation of any mower can result in foreign objects thrown into the eyes, which

`can result in severe eye damage. Always wear safety glasses or eye shields while operating your mower or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or

standard safety glasses.

Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive.

-Use only an approved container.

-Never remove gas cap or add fuel with the engine running. Allow engine to cool before refueling. Do not smoke.

-Never refuel the machine indoors.

-Never store the machine or fuel container inside where there is an open flame, such as a water heater.

Never run a machine inside a closed area.

Keep nuts and bolts, especially blade attachment bolts, tight and keep equipment in good condition.

Never tamper with safety devices. Check there proper operation regularly.

Keep machine free of grass, leaves, or other debris buildup. Clean oil or fuel spillage. Allow machine to cool before storing.

Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting.

Never make adjustments or repairs with the engine running.

Grass catcher components are subject to wear, damage, and deterioration, which could expose moving parts or allow objects to be thrown. Frequently check components and replace with manufacturer’s recom- mended parts, when necessary.

Mower blades are sharp and can cut. Wrap the blade(s) or wear gloves, and use extra caution when servicing them.

Check brake operation frequently. Adjust and service as required.

5

Image 5
Contents ZCBI48180 Operators Manual ModelsGood Service Contents General Operation Safety RulesII. Slope Operation Safe Operation Practices for RIDE-ON MowersSafe Operation Practices for RIDE-ON Mowers Do not III. ServiceIII. Children Safety Rules Customer Responsibilities SpecificationsTools Required For Assembly AssemblyTo Remove the Mower from Crate Before Removing Mower from the SkidControl Lever ARM HEX Bolts Neutral Slot Check the Tire Pressure ChecklistIZT Integrated Zeroturn Transaxle Bypass Linkages OperationControls Engine HOW to USE Your MowerDeck Blades To Adjust the Deck Cutting Height See Fig Rollers See Figure To Adjust ANTI-SCALPTo Operate Mower To Operate on HillsTo Transport See Fig To Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Before Each USE Maintenance ScheduleGeneral Recommendations Operator Presence System Lubrication ChartBlade Care TiresTo Sharpen Blade See Fig BatteryClean AIR INTAKE/COOLING Areas Clean AIR ScreenBelts EngineAIR Filter CleaningEngine OIL Filter Spark PlugsBefore Performing ANY Service or Adjustments Service and AdjustmentMower To Level DeckTo Replace Deck Belt To Replace IZT Integrated Zeroturn Transaxle Belt See Fig To Adjust Control Levers See Fig To Adjust the Seat See FigTo Remove Wheels for Repair Jump Starting EngineTo Adjust Park Brake Replacing Battery See FigTracking Adjustment Storage BatteryFuel System Engine OILCylinders OtherProblem Cause Correction Troubleshooting PointsAttachment Poor cut uneven ProblemcausecorrectionWiring Schematic