Yazoo/Kees ZCBI48180 manual To Sharpen Blade See Fig, Battery

Page 20

CUSTOMER RESPONSIBILITIES

IMPORTANT:TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON CUTTER HOUSING.

•Install and tighten blade bolt securely (45-55 ft./lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT IS HEAT TREATED.

CUTTER

HOUSING

BLADE

CENTER HOLE

STAR

BLADE BOLT (SPECIAL)

FIGURE 8

TO SHARPEN BLADE (See Fig. 9)

WARNING

When it is necessary to raise the mower for any repair or service, use jackstands to provide adequate sup- port. DO NOT rely on hydraulic or me- chanical jacks

Care should be taken to keep the blade bal- anced. An unbalanced blade will cause exces- sive vibration and eventual damage to mower and engine.

•The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower.

•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with balancer.)

NOTE: Do not use a nail for balancing the blade. The lobes of the center hole may appear to be centered, but are not.

•Slide blade on to an un-threaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If the blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.

CENTER HOLE

5/8" BOLT

BLADE

OR PIN

 

FIGURE 9

BATTERY

Your mower is equipped with a maintenance free battery and does not need servicing. However, periodic charging of the battery with an automotive type battery charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Recharge at 6-10 amperes for 1 hour

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Operators Manual Models ZCBI48180Good Service Contents Safety Rules General OperationII. Slope Operation Safe Operation Practices for RIDE-ON MowersSafe Operation Practices for RIDE-ON Mowers Do not III. ServiceIII. Children Safety Rules Specifications Customer ResponsibilitiesAssembly Tools Required For AssemblyTo Remove the Mower from Crate Before Removing Mower from the SkidControl Lever ARM HEX Bolts Neutral Slot Checklist Check the Tire PressureIZT Integrated Zeroturn Transaxle Bypass Linkages OperationControls Engine HOW to USE Your MowerDeck Blades To Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Rollers See FigureTo Operate Mower To Operate on HillsTo Transport See Fig Before Starting the Engine To Start Engine See FigCheck Engine OIL Level ADD GasolineMowing Tips Before Each USE Maintenance ScheduleGeneral Recommendations Lubrication Chart Operator Presence SystemBlade Care TiresBattery To Sharpen Blade See FigClean AIR Screen Clean AIR INTAKE/COOLING AreasBelts EngineCleaning AIR FilterEngine OIL Filter Spark PlugsService and Adjustment Before Performing ANY Service or AdjustmentsMower To Level DeckTo Replace Deck Belt To Replace IZT Integrated Zeroturn Transaxle Belt See Fig To Adjust the Seat See Fig To Adjust Control Levers See FigTo Remove Wheels for Repair Jump Starting EngineReplacing Battery See Fig To Adjust Park BrakeTracking Adjustment Battery StorageFuel System Engine OILOther CylindersTroubleshooting Points Problem Cause CorrectionProblemcausecorrection Attachment Poor cut unevenWiring Schematic
Top Page Image Contents