Yazoo/Kees ZVKH61273, ZVKW52253 manual Maintenance, Safety Instructions

Page 13
Maintenance

SAFETY INSTRUCTIONS

Maintenance

WARNING!

The engine must not be started when the driver’s floor plate or any protective plate for the mower deck’s drive belt is removed.

Safe Handling of Gasoline

To avoid personal injury or property damage, use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive.

Extinguish all cigarettes, cigars, pipes, and other sources of ignition.

Use only approved gasoline container.

Never remove gas cap or add fuel with the engine running. Allow engine to cool at least two (2) minutes before refueling.

Never fuel the machine indoors.

Never store the machine or fuel container where there is an open flame, spark, or pilot light such as on a water heater or other appliances.

Before you begin refueling, minimize the risk of static electricity by touching a metal surface.

Never fill containers inside a vehicle or on a truck or trailer bed with plastic liner. Always place containers on the ground away from your vehicle when filling.

Remove gas-powered equipment from the truck or tailer and refuel it on the ground. If this is not possible, then refuel such equipment with a portable container, rather than from a gasoline dispenser nozzle.

Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device.

If fuel is spilled on clothing, change clothing immediately.

Never overfill fuel tank. Replace gas cap and tighten securely.

Do not start the engine near spilled fuel.

Never use gasoline as a cleaning agent.

If leaks arise in the fuel system, the engine must not be started until the problem has been resolved.

8011-516

Never fill the fuel tank indoors

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before refueling

English-11

Image 13
Contents English Operator Manual   Page OPERATOR’S MANUAL RIDER MAX 2 SERIES ContentsEnglish-2 Introduction INTRODUCTIONCongratulations GeneralManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSRead Safety Instructions SAFETY INSTRUCTIONSGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Use protective goggles Transport Customer responsibilities Roll over Protection system ROPSControls CONTROLSControl Locations 1Forward 2Neutral 3Neutral slot, Neutral lock 1. Motion Control Levers4Reverse 3. Tracking knob 2. Hour Meter4. Parking Brake 6. Ignition Switch 5. Blade switch7. Fuses 9. Refueling 8. Seat Locking Device10. Fuel Shut Off Valve 11. Seat Adjustment Lever12. Choke Control 14. Lifting Lever for the Mower Deck 13. Throttle ControlCutting height pedal AccessoriesPump release valves Tighten the valve moderatelyOperation OPERATIONTraining Before Starting Roll bar and safety beltStarting the Engine 6.Move the throttle to the middle position 8.Open the fuel valve for the selected fuel tank IMPORTANT INFORMATION To start an engine with a weak battery Running Operating on hills Mowing patterns Mowing TipsStopping the Engine Vent screw on the hydraulic pump Moving by HandEnglish-34 8011-507Maintenance MAINTENANCEMaintenance Schedule The ignition key has been removed The engine is stoppedThe parking brake is on Battery Ignition System Checking the Safety System Ignition system Safety systemEnglish-40 8011-553Checking and Adjusting the Choke Cable Checking and Adjusting the Throttle CableChecking the Engines Cooling Air Intake Air filter maintenance Air filter indicator optional Filter replacementChecking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking the Parking Brake Checking Tire PressuresChecking the V-belts Faulty adjustment can cause an accidentPump belt Checking the BladesBlade replacement Adjusting the Mower Deck To adjust anti-scalprollers Engine oil coolerCaster Wheels Cleaning and WashingHardware Use protective glasses when cleaning and washingLubrication LUBRICATIONLubrication Schedule Shaft Bushings and Linkage Lubricating the Cables1. Hydraulic System, Oil Level Changing Oil and FiltersIMPORTANT INFORMATION Checking the Oil Level Oil Recommendations IMPORTANT INFORMATION 5. Front Wheel Mount 4.Throttle and Choke Cables, Lever Bearings6. Front Wheel Bearings 8. Mower Deck Height Adjuster7. Deck belt pulleys 10. Mower Deck Struts 9.Steering Control Shafts Tip the driver’s seatLubricating the steering control shafts Lubricating struts11. Changing the Oil Filter Trouble Shooting Guide TROUBLE SHOOTING GUIDEWrong fuel type Uneven mowing results STORAGE ServiceStorage Winter StorageTechnical Data TECHNICAL DATAEquipment Overall dimensionsProductivity ZVKH72303 ZVKH61303Cutting width Torque Specifications AccessoriesConformity Certificates CONFORMITY CERTIFICATESUSA requirements Service Journal SERVICE JOURNALDelivery Service After the First 8 Hours 4.Lubricate the belt adjuster, mower deck 25-HourService5.Lubricate the belt adjuster, hydraulic pumps 6.Check/clean the engine’s cooling air intake1.Perform the 25-hourservice 50-HourService5.Lubricate the cutting height adjuster 6.Check/adjust the parking brake100-HourService 300-HourService At Least Once Each Year English-78 Action SERVICE JOURNALDate, mtr reading, stamp, sign Action SERVICE JOURNALDate, mtr reading, stamp, sign Page 07/07 539 131260 IR
Related manuals
Manual 84 pages 62.74 Kb