Yazoo/Kees ZVKH61273, ZVKW52253 manual Operating on hills, Operation, Important Information

Page 33
Operating on hills

OPERATION

In order, for example, to turn right while moving forward, move the right control towards the neutral position. The rotation of the right wheel is reduced and the machine turns to the right.

Turning on the spot can be achieved by moving one control backward (behind the neutral position) and carefully moving the other steering control forward from its neutral position.

Operating on hills

Read "Driving on Slopes" in the "Safety Instructions".

WARNING!

Do not drive up or down hills with slopes greater than 10 degrees. And do not drive across any slopes.

The slowest speed possible should be used before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, pull drive levers into the neutral position and push to the outside of the unit and engage the park brake.

IMPORTANT INFORMATION

Control levers return to neutral when released. This may cause the mower to suddenly stop.

To restart movement, release the park brake.

Pull the control levers back to the center of the mower and press forward to regain forward motion.

Make all turns slowly.

8011-640

Stopping conditions

8011-511

Released parking brake

English-31

Image 33
Contents English Operator Manual   Page OPERATOR’S MANUAL RIDER MAX 2 SERIES ContentsEnglish-2 Introduction INTRODUCTIONCongratulations GeneralManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSRead SAFETY INSTRUCTIONS Safety InstructionsGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Use protective goggles Transport Customer responsibilities Roll over Protection system ROPSCONTROLS ControlsControl Locations 1. Motion Control Levers 1Forward 2Neutral 3Neutral slot, Neutral lock4Reverse 2. Hour Meter 3. Tracking knob4. Parking Brake 5. Blade switch 6. Ignition Switch7. Fuses 9. Refueling 8. Seat Locking Device11. Seat Adjustment Lever 10. Fuel Shut Off Valve12. Choke Control 14. Lifting Lever for the Mower Deck 13. Throttle ControlCutting height pedal AccessoriesPump release valves Tighten the valve moderatelyOPERATION OperationTraining Roll bar and safety belt Before StartingStarting the Engine 6.Move the throttle to the middle position 8.Open the fuel valve for the selected fuel tank IMPORTANT INFORMATION To start an engine with a weak battery Running Operating on hills Mowing patterns Mowing TipsStopping the Engine Vent screw on the hydraulic pump Moving by HandEnglish-34 8011-507MAINTENANCE MaintenanceMaintenance Schedule The engine is stopped The ignition key has been removedThe parking brake is on Battery Ignition System Checking the Safety System Ignition system Safety systemEnglish-40 8011-553Checking and Adjusting the Throttle Cable Checking and Adjusting the Choke CableChecking the Engines Cooling Air Intake Air filter maintenance Air filter indicator optional Filter replacementChecking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking the Parking Brake Checking Tire PressuresChecking the V-belts Faulty adjustment can cause an accidentPump belt Checking the BladesBlade replacement Adjusting the Mower Deck To adjust anti-scalprollers Engine oil coolerCaster Wheels Cleaning and WashingHardware Use protective glasses when cleaning and washingLUBRICATION LubricationLubrication Schedule Shaft Bushings and Linkage Lubricating the Cables1. Hydraulic System, Oil Level Changing Oil and FiltersIMPORTANT INFORMATION Checking the Oil Level Oil Recommendations IMPORTANT INFORMATION 5. Front Wheel Mount 4.Throttle and Choke Cables, Lever Bearings8. Mower Deck Height Adjuster 6. Front Wheel Bearings7. Deck belt pulleys 10. Mower Deck Struts 9.Steering Control Shafts Tip the driver’s seatLubricating the steering control shafts Lubricating struts11. Changing the Oil Filter Trouble Shooting Guide TROUBLE SHOOTING GUIDEWrong fuel type Uneven mowing results STORAGE ServiceStorage Winter StorageTechnical Data TECHNICAL DATAOverall dimensions EquipmentProductivity ZVKH72303 ZVKH61303Cutting width Torque Specifications AccessoriesCONFORMITY CERTIFICATES Conformity CertificatesUSA requirements SERVICE JOURNAL Service JournalDelivery Service After the First 8 Hours 4.Lubricate the belt adjuster, mower deck 25-HourService5.Lubricate the belt adjuster, hydraulic pumps 6.Check/clean the engine’s cooling air intake1.Perform the 25-hourservice 50-HourService5.Lubricate the cutting height adjuster 6.Check/adjust the parking brake100-HourService 300-HourService At Least Once Each Year English-78 SERVICE JOURNAL ActionDate, mtr reading, stamp, sign SERVICE JOURNAL ActionDate, mtr reading, stamp, sign Page 07/07 539 131260 IR
Related manuals
Manual 84 pages 62.74 Kb