Yazoo/Kees ZVKH61273, ZVKW52253 manual To start an engine with a weak battery, Operation

Page 31
To start an engine with a weak battery

OPERATION

To start an engine with a weak battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See “Battery" in the “Maintenance" section).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower battery to start other vehicles.

To attach jumper cables

• Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully

charged battery.

8011-642

 

 

Jumper cables connection

Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

Remove BLACK cable first from chassis and then from the fully charged battery.

Remove RED cable last from both batteries.

English-29

Image 31
Contents   Operator ManualEnglish  Page OPERATOR’S MANUAL RIDER MAX 2 SERIES ContentsEnglish-2 General INTRODUCTIONIntroduction CongratulationsManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSRead Safety Instructions SAFETY INSTRUCTIONSGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Use protective goggles Transport Customer responsibilities Roll over Protection system ROPSControls CONTROLSControl Locations 1Forward 2Neutral 3Neutral slot, Neutral lock 1. Motion Control Levers4Reverse 3. Tracking knob 2. Hour Meter4. Parking Brake 6. Ignition Switch 5. Blade switch7. Fuses 9. Refueling 8. Seat Locking Device10. Fuel Shut Off Valve 11. Seat Adjustment Lever12. Choke Control 14. Lifting Lever for the Mower Deck 13. Throttle ControlTighten the valve moderately AccessoriesCutting height pedal Pump release valvesOperation OPERATIONTraining Before Starting Roll bar and safety beltStarting the Engine 6.Move the throttle to the middle position 8.Open the fuel valve for the selected fuel tank IMPORTANT INFORMATION To start an engine with a weak battery Running Operating on hills Mowing patterns Mowing TipsStopping the Engine 8011-507 Moving by HandVent screw on the hydraulic pump English-34Maintenance MAINTENANCEMaintenance Schedule The ignition key has been removed The engine is stoppedThe parking brake is on Battery Ignition System Checking the Safety System 8011-553 Safety systemIgnition system English-40Checking and Adjusting the Choke Cable Checking and Adjusting the Throttle CableChecking the Engines Cooling Air Intake Air filter maintenance Air filter indicator optional Filter replacementChecking the Fuel Pump’s Air Filter Replacing the Fuel FilterFaulty adjustment can cause an accident Checking Tire PressuresChecking the Parking Brake Checking the V-beltsPump belt Checking the BladesBlade replacement Adjusting the Mower Deck To adjust anti-scalprollers Engine oil coolerUse protective glasses when cleaning and washing Cleaning and WashingCaster Wheels HardwareLubrication LUBRICATIONLubrication Schedule Changing Oil and Filters Lubricating the CablesShaft Bushings and Linkage 1. Hydraulic System, Oil LevelIMPORTANT INFORMATION Checking the Oil Level Oil Recommendations IMPORTANT INFORMATION 5. Front Wheel Mount 4.Throttle and Choke Cables, Lever Bearings6. Front Wheel Bearings 8. Mower Deck Height Adjuster7. Deck belt pulleys Lubricating struts 9.Steering Control Shafts Tip the driver’s seat10. Mower Deck Struts Lubricating the steering control shafts11. Changing the Oil Filter Trouble Shooting Guide TROUBLE SHOOTING GUIDEWrong fuel type Uneven mowing results Winter Storage ServiceSTORAGE StorageTechnical Data TECHNICAL DATAEquipment Overall dimensionsProductivity ZVKH72303 ZVKH61303Cutting width Torque Specifications AccessoriesConformity Certificates CONFORMITY CERTIFICATESUSA requirements Service Journal SERVICE JOURNALDelivery Service After the First 8 Hours 6.Check/clean the engine’s cooling air intake 25-HourService4.Lubricate the belt adjuster, mower deck 5.Lubricate the belt adjuster, hydraulic pumps6.Check/adjust the parking brake 50-HourService1.Perform the 25-hourservice 5.Lubricate the cutting height adjuster100-HourService 300-HourService At Least Once Each Year English-78 Action SERVICE JOURNALDate, mtr reading, stamp, sign Action SERVICE JOURNALDate, mtr reading, stamp, sign Page 07/07 539 131260 IR
Related manuals
Manual 84 pages 62.74 Kb