Yazoo/Kees ZVKH61273, ZVKW52253 manual Safety Instructions, General Operation

Page 9
SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONS

Safety Instructions

These instructions are for your safety. Read them carefully.

WARNING!

This symbol means that important safety instructions need to be emphasized. It concerns your safety.

IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.

General Operation

Read, understand, and follow all instructions on the machine and in the manual before starting.

Do not put hands or feet near rotating parts or under the machine. Keep clear of the discharge opening at all times.

Only allow responsible adults, who are familiar with the instructions, to operate the machine.

Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by the blades.

Be sure the area is clear of bystanders before operating. Stop machine if anyone enters the area.

Never carry passengers. The machine is only intended for use by one person.

Do not mow in reverse unless absolutely necessary. Always look down and behind before and while backing.

Never direct discharged material toward anyone. Avoid discharging material against a wall or obstruction. Material may ricochet back toward the operator. Stop the blades when crossing gravel surfaces.

Do not operate machine without the entire grass catcher, discharge guard, or other safety devices in place and working

Slow down before turning.

Never leave a running machine unattended. Always turn off blades, set parking brake, stop engine, and remove keys before dismounting.

8011-512

Read the operator’s manual before starting the machine

8011-513

Clear the area of objects before mowing

8011-520

Never take passengers

English-7

Image 9
Contents English Operator Manual   Page OPERATOR’S MANUAL RIDER MAX 2 SERIES ContentsEnglish-2 Introduction INTRODUCTIONCongratulations GeneralManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSRead SAFETY INSTRUCTIONS Safety InstructionsGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Use protective goggles Transport Customer responsibilities Roll over Protection system ROPSCONTROLS ControlsControl Locations 1. Motion Control Levers 1Forward 2Neutral 3Neutral slot, Neutral lock4Reverse 2. Hour Meter 3. Tracking knob4. Parking Brake 5. Blade switch 6. Ignition Switch7. Fuses 9. Refueling 8. Seat Locking Device11. Seat Adjustment Lever 10. Fuel Shut Off Valve12. Choke Control 14. Lifting Lever for the Mower Deck 13. Throttle ControlCutting height pedal AccessoriesPump release valves Tighten the valve moderatelyOPERATION OperationTraining Roll bar and safety belt Before StartingStarting the Engine 6.Move the throttle to the middle position 8.Open the fuel valve for the selected fuel tank IMPORTANT INFORMATION To start an engine with a weak battery Running Operating on hills Mowing patterns Mowing TipsStopping the Engine Vent screw on the hydraulic pump Moving by HandEnglish-34 8011-507MAINTENANCE MaintenanceMaintenance Schedule The engine is stopped The ignition key has been removedThe parking brake is on Battery Ignition System Checking the Safety System Ignition system Safety systemEnglish-40 8011-553Checking and Adjusting the Throttle Cable Checking and Adjusting the Choke CableChecking the Engines Cooling Air Intake Air filter maintenance Air filter indicator optional Filter replacementChecking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking the Parking Brake Checking Tire PressuresChecking the V-belts Faulty adjustment can cause an accidentPump belt Checking the BladesBlade replacement Adjusting the Mower Deck To adjust anti-scalprollers Engine oil coolerCaster Wheels Cleaning and WashingHardware Use protective glasses when cleaning and washingLUBRICATION LubricationLubrication Schedule Shaft Bushings and Linkage Lubricating the Cables1. Hydraulic System, Oil Level Changing Oil and FiltersIMPORTANT INFORMATION Checking the Oil Level Oil Recommendations IMPORTANT INFORMATION 5. Front Wheel Mount 4.Throttle and Choke Cables, Lever Bearings8. Mower Deck Height Adjuster 6. Front Wheel Bearings7. Deck belt pulleys 10. Mower Deck Struts 9.Steering Control Shafts Tip the driver’s seatLubricating the steering control shafts Lubricating struts11. Changing the Oil Filter Trouble Shooting Guide TROUBLE SHOOTING GUIDEWrong fuel type Uneven mowing results STORAGE ServiceStorage Winter StorageTechnical Data TECHNICAL DATAOverall dimensions EquipmentProductivity ZVKH72303 ZVKH61303Cutting width Torque Specifications AccessoriesCONFORMITY CERTIFICATES Conformity CertificatesUSA requirements SERVICE JOURNAL Service JournalDelivery Service After the First 8 Hours 4.Lubricate the belt adjuster, mower deck 25-HourService5.Lubricate the belt adjuster, hydraulic pumps 6.Check/clean the engine’s cooling air intake1.Perform the 25-hourservice 50-HourService5.Lubricate the cutting height adjuster 6.Check/adjust the parking brake100-HourService 300-HourService At Least Once Each Year English-78 SERVICE JOURNAL ActionDate, mtr reading, stamp, sign SERVICE JOURNAL ActionDate, mtr reading, stamp, sign Page 07/07 539 131260 IR
Related manuals
Manual 84 pages 62.74 Kb