Yazoo/Kees ZVKW52253, ZVKH61273 manual Air filter maintenance, Maintenance

Page 44
Air filter maintenance

MAINTENANCE

Air filter maintenance

If the engine seems weak or runs unevenly, the air filter may be clogged. If running with a dirty air filter, the spark plugs can become fouled.

For this reason, it is important to replace the air filter regularly (see the heading Maintenance Schedule for the proper service interval).

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before refueling.

Cleaning/replacing the air filter is carried out as follows:

IMPORTANT INFORMATION

Do not used compressed air to clean the air filter.

Do not wash the paper filter. Do not oil the paper filter.

Dust cap

Check the dust cap every day by pressing the rubber valve with two fingers to let out the dirt.

IMPORTANT INFORMATION

The end cover must be installed with the rubber valve pointing downwards, otherwise the rubber valve will not function.

Clean the dust cap by removing the end cover of the the air cleaner and clean inside.

8011-447

Pressing the rubber valve

8011-448

Removing the end cover

English-42

Image 44
Contents Operator Manual English   Page Contents OPERATOR’S MANUAL RIDER MAX 2 SERIESEnglish-2 INTRODUCTION IntroductionCongratulations GeneralGood Service Manufacturing NumberSYMBOLS AND DECALS Symbols and DecalsRead General Operation SAFETY INSTRUCTIONSSafety Instructions English-8 Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Use protective goggles Transport Roll over Protection system ROPS Customer responsibilitiesControl Locations CONTROLSControls 4Reverse 1. Motion Control Levers1Forward 2Neutral 3Neutral slot, Neutral lock 4. Parking Brake 2. Hour Meter3. Tracking knob 7. Fuses 5. Blade switch6. Ignition Switch 8. Seat Locking Device 9. Refueling12. Choke Control 11. Seat Adjustment Lever10. Fuel Shut Off Valve 13. Throttle Control 14. Lifting Lever for the Mower DeckAccessories Cutting height pedalPump release valves Tighten the valve moderatelyTraining OPERATIONOperation Starting the Engine Roll bar and safety beltBefore Starting 6.Move the throttle to the middle position 8.Open the fuel valve for the selected fuel tank OPERATION To start an engine with a weak battery Running Operating on hills Mowing Tips Mowing patternsStopping the Engine Moving by Hand Vent screw on the hydraulic pumpEnglish-34 8011-507Maintenance Schedule MAINTENANCEMaintenance The parking brake is on The engine is stoppedThe ignition key has been removed Battery Ignition System Checking the Safety System Safety system Ignition systemEnglish-40 8011-553Checking the Engines Cooling Air Intake Checking and Adjusting the Throttle CableChecking and Adjusting the Choke Cable Air filter maintenance Filter replacement Air filter indicator optionalReplacing the Fuel Filter Checking the Fuel Pump’s Air FilterChecking Tire Pressures Checking the Parking BrakeChecking the V-belts Faulty adjustment can cause an accidentChecking the Blades Pump beltBlade replacement Adjusting the Mower Deck Engine oil cooler To adjust anti-scalprollersCleaning and Washing Caster WheelsHardware Use protective glasses when cleaning and washingLubrication Schedule LUBRICATIONLubrication Lubricating the Cables Shaft Bushings and Linkage1. Hydraulic System, Oil Level Changing Oil and FiltersLUBRICATION Checking the Oil Level Oil Recommendations LUBRICATION 4.Throttle and Choke Cables, Lever Bearings 5. Front Wheel Mount7. Deck belt pulleys 8. Mower Deck Height Adjuster6. Front Wheel Bearings 9.Steering Control Shafts Tip the driver’s seat 10. Mower Deck StrutsLubricating the steering control shafts Lubricating struts11. Changing the Oil Filter TROUBLE SHOOTING GUIDE Trouble Shooting GuideWrong fuel type Uneven mowing results Service STORAGEStorage Winter StorageTECHNICAL DATA Technical DataProductivity Overall dimensionsEquipment ZVKH61303 ZVKH72303TECHNICAL DATA Accessories Torque SpecificationsUSA requirements CONFORMITY CERTIFICATESConformity Certificates Delivery Service SERVICE JOURNALService Journal After the First 8 Hours 25-HourService 4.Lubricate the belt adjuster, mower deck5.Lubricate the belt adjuster, hydraulic pumps 6.Check/clean the engine’s cooling air intake50-HourService 1.Perform the 25-hourservice5.Lubricate the cutting height adjuster 6.Check/adjust the parking brake100-HourService 300-HourService At Least Once Each Year English-78 Date, mtr reading, stamp, sign SERVICE JOURNALAction Date, mtr reading, stamp, sign SERVICE JOURNALAction Page 539 131260 IR 07/07
Related manuals
Manual 84 pages 62.74 Kb