Yazoo/Kees ZVKW52253, ZVKH61273 manual Cleaning and Washing, Caster Wheels, Hardware, Maintenance

Page 52
Cleaning and Washing

MAINTENANCE

Cleaning and Washing

Regular cleaning and washing, especially under the mower deck, will increase the machine’s lifespan. Make it a habit to clean the machine directly after use (after it is cooled), before the dirt sticks.

Do not spray water on the top of the mower deck. Use compressed air to clean the top side of mower deck. Regularly clean deck and underside of deck, avoid spraying engine and electrical components with water.

Use protective glasses when cleaning and washing.

Caster Wheels

Check every 200 hours. Lift front of unit off of ground so caster wheels can rotate freely. Tighten caster bolt (34) then back off 1/2 turn. Check that wheel rotates freely. If wheel does not rotate freely back the caster bolt off in 1/4 turn increments until wheel rotates freely.

IMPORTANT INFORMATION

DO NOT add any type of tire liner or foam fill material to the tires. Excessive loads created by foam filled tires will cause premature failures.

Only use O.E.M. specified tires.

Foam filled tires or solid tires will void the warranty.

Hardware

Check daily. Inspect the entire machine for loose or missing hardware.

8050-092

Cleaning

8011-619

Caster wheels

English-50

Image 52
Contents Operator Manual English   Page Contents OPERATOR’S MANUAL RIDER MAX 2 SERIESEnglish-2 INTRODUCTION IntroductionCongratulations GeneralGood Service Manufacturing NumberSYMBOLS AND DECALS Symbols and DecalsRead Safety Instructions SAFETY INSTRUCTIONSGeneral Operation English-8 Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Use protective goggles Transport Roll over Protection system ROPS Customer responsibilitiesControls CONTROLSControl Locations 1Forward 2Neutral 3Neutral slot, Neutral lock 1. Motion Control Levers4Reverse 3. Tracking knob 2. Hour Meter4. Parking Brake 6. Ignition Switch 5. Blade switch7. Fuses 8. Seat Locking Device 9. Refueling10. Fuel Shut Off Valve 11. Seat Adjustment Lever12. Choke Control 13. Throttle Control 14. Lifting Lever for the Mower DeckAccessories Cutting height pedalPump release valves Tighten the valve moderatelyOperation OPERATIONTraining Before Starting Roll bar and safety beltStarting the Engine 6.Move the throttle to the middle position 8.Open the fuel valve for the selected fuel tank OPERATION To start an engine with a weak battery Running Operating on hills Mowing Tips Mowing patternsStopping the Engine Moving by Hand Vent screw on the hydraulic pumpEnglish-34 8011-507Maintenance MAINTENANCEMaintenance Schedule The ignition key has been removed The engine is stoppedThe parking brake is on Battery Ignition System Checking the Safety System Safety system Ignition systemEnglish-40 8011-553Checking and Adjusting the Choke Cable Checking and Adjusting the Throttle CableChecking the Engines Cooling Air Intake Air filter maintenance Filter replacement Air filter indicator optionalReplacing the Fuel Filter Checking the Fuel Pump’s Air FilterChecking Tire Pressures Checking the Parking BrakeChecking the V-belts Faulty adjustment can cause an accidentChecking the Blades Pump beltBlade replacement Adjusting the Mower Deck Engine oil cooler To adjust anti-scalprollersCleaning and Washing Caster WheelsHardware Use protective glasses when cleaning and washingLubrication LUBRICATIONLubrication Schedule Lubricating the Cables Shaft Bushings and Linkage1. Hydraulic System, Oil Level Changing Oil and FiltersLUBRICATION Checking the Oil Level Oil Recommendations LUBRICATION 4.Throttle and Choke Cables, Lever Bearings 5. Front Wheel Mount6. Front Wheel Bearings 8. Mower Deck Height Adjuster7. Deck belt pulleys 9.Steering Control Shafts Tip the driver’s seat 10. Mower Deck StrutsLubricating the steering control shafts Lubricating struts11. Changing the Oil Filter TROUBLE SHOOTING GUIDE Trouble Shooting GuideWrong fuel type Uneven mowing results Service STORAGEStorage Winter StorageTECHNICAL DATA Technical DataEquipment Overall dimensionsProductivity ZVKH61303 ZVKH72303TECHNICAL DATA Accessories Torque SpecificationsConformity Certificates CONFORMITY CERTIFICATESUSA requirements Service Journal SERVICE JOURNALDelivery Service After the First 8 Hours 25-HourService 4.Lubricate the belt adjuster, mower deck5.Lubricate the belt adjuster, hydraulic pumps 6.Check/clean the engine’s cooling air intake50-HourService 1.Perform the 25-hourservice5.Lubricate the cutting height adjuster 6.Check/adjust the parking brake100-HourService 300-HourService At Least Once Each Year English-78 Action SERVICE JOURNALDate, mtr reading, stamp, sign Action SERVICE JOURNALDate, mtr reading, stamp, sign Page 539 131260 IR 07/07
Related manuals
Manual 84 pages 62.74 Kb