Multiquip LT6D operation manual Major Components Front/ Rear

					components
			24
			25	32	34	33
27
29	28	26	29	31		31
				30
	REAR VIEW				FRONT VIEW
		Figure 5. Major Components (Front/ Rear)

24.Rear Reflectors — There are two reflectors mounted on the rear light tower panel. These reflectors provide better visibility in dark conditions.

25.Engine Exhaust Pipe — Directs engine exhaust to the rear of the light tower. NEVER block this exhaust pipe with obstructions. ALWAYS place the light tower in an area free of obstructions.

26.Right Brake Light — Before towing the light tower, make sure that this light is operational and is working correctly. NEVER tow the light tower if this light is inoperative.

27.Left Brake Light — Before towing the light tower, make sure that this light is operational and is working correctly. NEVER tow the light tower if this light is inoperative

28.License Light — This light illuminates the license plate. Whenever towing of the light tower is required, make sure this light is operational.

29.Rear Jackstands/Outriggers — There are two jackstands located at the rear of the trailer. Use these jackstands and outriggers to level and support the light tower.

30.Tires — This light tower uses a ST175-80D size tire. Replace with only recommended tire size. NEVER tow light tower with bad or worn tires.

31.Front Jackstands/Outriggers — There are two jackstands located at the front of the trailer. Use these jackstands and outriggers to level and support the light tower.

32.Left-Side Ballast — This area of the light tower encloses the components for the ballast assembly lights 1 and 3 (top).

33.Right-Side Ballast — This area of the light tower encloses the components for the ballast assembly lights 2 and 4 (bottom).

34.Ground Point — Connect earth ground (ground rod) to this connection point if required.

page 22 — LT6D LIGHT TOWER • operation manual — rev. #0 (07/16/13)