Multiquip LT6D operation manual Normal Operation Indicator This alarm

control panel

Figure 6 shows the location of the controls and indicators on the LT6D control panel. Below is a breif description of each component.

1.Main Circuit Breaker (CB1) — A double-pole 50 amp circuit breaker which protects the 120/240 VAC twist-lock receptacle from overload. In addition it allows voltage to be supplied to the light circuit breakers (CB2/ CB3), and GFCI breaker (CB4).

2.120/240 VAC Twist-Lock Receptacle — This dual voltage twist-lock receptacle provides 240 VAC @ 25 amps or 120 VAC @ 25 amps X2.

3.Panel Light — When the cabinet door is raised, the light will automatically come on.When the cabinet door closes, the switch is depressed and the light turns off.

4.Hour Meter — This digital hour meter indicates the number of hours machine has been in use.

5.Circuit Breaker (CB3) — Single pole, 20 amp circuit breaker, turns on bottom lights.

6.Circuit Breaker (CB2) — Single pole, 20 amp circuit breaker, turns on top lights.

7.GFCI Receptacle — Provides 120 VAC @ 15 amps.

8.GFCI Circuit Breaker (CB4) — Single-pole, 15 amp circuit breaker, protects GFCI receptacle from overload.

9.Engine Status Module — Displays engine status via LEDs.Perform engine maintenance depending on alarm status.

10.Normal Operation Indicator — This alarm

LED (green) lights when the engine is OK functioning normal.

11.Oil Pressure Alarm Indicator — This alarm LED flashes when the oil pressure has fallen too low for normal engine operation.The LED will stay on until the problem is corrected.

12.Water Temperature Alarm Indicator — This alarm LED flashes when the water temperature becomes too hot for normal engine operation. This condition will shut down the engine. The LED will stay on until the problem is corrected.

13.Alternator Alarm Indicator — This LED turns on when the engine has shut down because the electrical charging system is not working properly.

14.PreHeat Indicator — This LED turns on when the ignition key is turned to the ON position indicating that the glow plugs are warming up. When the LED goes off, the engine is ready for starting. If the LED is flashing, a low battery charge is detected.

15.Ignition Key Switch — Insert key into ignition switch and turn clockwise to the ON position to warm the glow plugs. When pre-heat indicator light goes OFF, turn the key to the START position. Release key when engine starts.

16.Air Filter Alarm Indicator — This LED flashes when a blockage or problem with the air filter is detected.

LT6D LIGHT TOWER • operation manual — rev. #0 (07/16/13) — page 25