Multiquip LT6D operation manual Setup, Indoor Installation, Lamp power cable connections

Indoor Installation

Exhaust gases from diesel engines are extremely poisonous. Whenever an engine is installed indoors the exhaust fumes must be vented to the outside. The engine should be installed at least two feet from any outside wall.

Using an exhaust pipe which is too long or too small can cause excessive back pressure which will cause the engine to heat excessively and possibly burn the valves.

Eliminate the danger of deadly carbon monoxide gas. Remember that exhaust fumes from any gasoline or diesel engine are very poisonous if discharged in a closed area.

If the light tower is installed indoors, you must make provisions for venting the engine exhaust to the outside of the building.

lamp power cable connections

1.Locate the 4 key-lock female 3-pin DIN connectors on the T-bar as shown in Figure 12.

A

setup

4.Align the key tab (B) on the male connector with the slot or key (A) on the female connector and press together until seated. Connect the light power cables to the T-bar as referenced in Table 7 and Figure 14.

Table 7. Light Power Cable Connections

Power Cable			T-Bar Receptacle
Light 1			J1
Light 2			J2
Light 3			J3
Light 4			J4
		FRONT
			REAR
			LIGHT	3
	1
LIGHT
J1		J3
			J4
		J2
			4
			LIGHT
LIGHT		2
			MAST RAISED

Figure 12. 3-Pin DIN Female Connector

2.Next, locate the slot or key (A) on each female connector as shown in Figure 12.

3.On the corresponding male connector, locate the key tab (B) as shown in Figure 13.

B

Figure 13. Male Connector

Figure 14. Light Power Cable Connections

5.Secure all cable connectors by screwing the knurled locking nut of the male connector to the threaded portion of the female connector to ensure good contact between the two connectors. See Figure 14.

page 30 — LT6D LIGHT TOWER • operation manual — rev. #0 (07/16/13)