Multiquip DCA-150SSKII operation manual Close all engine enclosure doors Figure

Table of Contents

DCA-150SSKII — GENERATOR START-UP PROCEDURE (MANUAL)

4. Close all engine enclosure doors (Figure 45).

7.After engine starts, verify that the "Engine Running" status LED (Figure 49) on the Microprocessor Engine Control Module (MPEC) display is "ON" (lit).

Figure 45. Engine Enclosure Doors

5.When starting the generator in COLD weather conditions, press and hold the engine preheat button (Figure 46) until the pre-heat lamp (Figure 47) is lit (ON).

Figure 49. MPEC Engine Running Status LED

8.If the unit has an ignition switch(Figure 50), turn the key to the right, until the engine starts. Then release the key to 'Run'.

Figure 46. Engine Pre-Heat Button

Figure 50. Ignition Switch (Run)

Figure 47. Engine Pre-Heat Lamp

6.Place the Off/Manual/Auto switch (Figure 48) in the MANUAL position (down).Observe that the engine begins to crank.

9.Pull and turn the engine throttle lever (Figure 51) to increase the engine speed to high.

Figure 51. Engine Throttle Lever (High)

10. If the generator is equipped without the engine throttle lever, set the idle control switch to the "ON" position. (See figure 52)

Figure 48. Off/Manual/Auto Switch (Manual)

Figure 52. Idle Control (ON)

PAGE 48 —DCA-150SSKII— PARTS AND OPERATION MANUAL — REV. #2 (05/08/01)