Multiquip DCA-150SSKII operation manual Voltage Meter Volts

Table of Contents

DCA-150SSKII — GENERATOR START-UP PROCEDURE (MANUAL)

11.The generator's frequency meter (Figure 53) displays the 60 cycle output frequency in HERTZ.

14.The engine oil pressure gauge (Figure 57) will indicate the oil pressure (kg/ cm2) of the engine. Under normal operating conditions the oil pressure should be approximately 25 psi.

Figure 53. Frequency Meter (Hz)

12.The generator's voltage meter (Figure 54) displays the 120 VAC in VOLTS. If the voltage is not within the specified frequency tolerance, use the voltage adjustment control knob (Figure 55) to increase or decrease the desired voltage.

Figure 57. Oil Pressure Gauge

15.The coolant temperature gauge (Figure 58) will indicate the coolant temperature. Under normal operating conditions the coolant temperature should be between 105 and 215 degrees fahrenheit (Green Zone).

WATER TEMP

Figure 58. Coolant Temperature Gauge

Figure 54. Voltage Meter (Volts)

16. The tachometer (Figure 59) will indicate the speed of the engine when the generator is operating. Under normal operating conditions this speed should be approximately 1800 RPM’s.

Figure 55. Voltage Adjust Control Knob

13.The ammeter (Figure 56) will indicate zero amps with no load applied. When a load is applied, this meter will indicate the amount of current that the load is drawing

from the generator’s alternator.			Figure 59. Engine Tachometer
	40
20	60
0		75

A

Figure 56. Ammeter (No Load)

DCA-150SSKII — PARTS AND OPERATION MANUAL— REV. #1 (05/08/01) — PAGE 49