Land Pride Z52 , Z60, Z72 Moving Mower with Stalled Engine, Front of mower Faces This Direction

Page 18

Land Pride

Section 2 Operation

IMPORTANT: The engine starter should not be operated for periods longer then 30 seconds at a time. An interval of at least two minutes should be allowed between such cranking periods to protect the starter from overheating and burn-out.

5.Perform test to make sure safety start interlock system is operating properly. Refer to Safety start interlock system section.

6.As soon as engine begins to run, check to make certain the oil warning light is off. If not, stop engine immediately and check for the cause.

7.Allow the engine to idle a few minutes before advancing the throttle and/or engaging the deck clutch.

8.Before stopping the engine, place the control levers in the brake position, disengage the deck clutch, and throttle back to low idle for a couple of minutes; then rotate ignition key counter-clockwise to the OFF position. Remove the key from switch before leaving the seat.

!WARNING!

Never leave the machine unattended with key in ignition switch.

Moving Mower with Stalled Engine

If it becomes necessary to move the mower when the engine is inoperative, the hydraulic pumps are equipped with bypass valves. Before moving the unit, turn bypass valves counter clockwise one-half to one revolution. The valve stems on each hydraulic pump are located near the top and are identified as a hex stud. Refer to Figure 2-8.

Bypass

19064

Valve

Bypass Valve

 

Figure 2-8

Do not tow the machine. Move it by hand or use a winch to load on a trailer for transporting.

IMPORTANT: Always make certain the two bypass valves are returned to their operating position before running the mower following repairs.

Front of mower Faces This Direction

N

 

 

 

N

Forward Travel

Pivot Right Turn

Forward Travel

Reverse Travel

Reverse Travel

 

 

Right Turn

Right Turn

 

N= Neutral Position

Direction of arrows indicate direction of mower movement.

Steering

Figure 2-9

16 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M

03/11/03

Image 18
Contents Accu-Z Table of Contents For Your Protection Be Aware of Signal WordsKeep Riders Off Machinery Shutdown and StoragePractice Safe Maintenance Safety at All TimesPrepare for Emergencies Wear Protective EquipmentAvoid High Pressure Fluids Hazard Important Safety Information 838-303C838-307C 838-308C 838-310C 838-399COwner Assistance Using This ManualApplication IntroductionControl Lever and Seat Assembly Remote Air Cleaner AssemblyAssembly and Set-Up Remote Air Cleaner Assembly Optional Equipment AssembliesControl Lever Extensions Accu-Vac Assembly Mower Deck PreparationBlower, Pulley and Pulley Cover Assembly Blower Drive BeltBagger Assembly Bagger Assembly Operation Ignition SwitchControls Throttle ControlDeck Height Deck Lift Locking Pin Blade Engagement SwitchControl Levers Control LeversEngine Starting Safety Start Interlock SystemInstrumentation Hour MeterMoving Mower with Stalled Engine Front of mower Faces This DirectionSteering Driving the MowerOperating Suggestions To Stop or Decrease SpeedMower Deck Operation Operating Instructions Steering Linkage AdjustmentsTorque Values Control Lever Park Brake SlotControl Lever Neutral Adjustment Jam NutStop Control Lever Top Nylock Nut Reverse Spring Reverse Spring AdjustmentControl Lever Stops Nylock Nut LinkageSteering Dampener Park Brake AdjustmentControl Lever Adjustment Steering Dampener Upper Control Lever Cap Screw LowerBy-Pass Valve Jam Nut Front Brake Link Right SideControl Lever Park Brake Slot Outside Edge Travel Slot Brake Linkage TurnbuckleEngine RPM Setting Hydraulic Pump Belt AdjustmentDeck Drive Belt Adjustment Deck Leveling and Height AdjustmentStop Handle Height Adjusting Blocks Deck Level AdjustmentsDeck Lift Threaded Rod Nut Nut Chain Bolt Adjuster Jam Nut Hardware Deck Lift Threaded Rod Foot Pedal Nut Nut ChainLift Block Deck Lift Rod Assist Springs Deck Cutting Height Adjustment Height Adjusting Stop PlateAnti-Scalp Rollers Adjusting Holes Anti-Scalp RollersMaintenance and Lubrication Top View Deck Top View Bottom ViewMaintenance Schedule Tires MaintenanceRefer to Tire Inflation Chart Torque ValuesBattery Hour MeterLubrication Electrical System Seat Platform Seat Platform Catch Control Lever Access to Engine and Hydraulic PumpsHydraulic System Hydraulic Reservoir Hydraulic FilterFuel System Engine Oil and FilterFuel Filter Engine Oil Filler Tube Oil Filter Drain Plug Improper InstallationEngine Air Filter Over ServicingDamaged Filter, Seals or Canister Engine Air Filter Service ProcedureGeneral Engine Maintenance Incorrect Air Filter ElementMower Blade Removal Belt ReplacementMower Blade Maintenance Lift Jack OptionPreparation of Engine for Storage New Season PreparationSpecifications and Capacities Weight Kit Safety FeaturesIndicators ParkingFeatures and Benefits 52, 60 or 72 Cutting widthTroubleshooting Tire Tire Inflation ChartAppendix Inflation PSIWarranty Corporate Office P.O. Box Salina, Kansas 67402-5060 USA
Related manuals
Manual 6 pages 11.76 Kb

Z60, Z52, Z52 , Z60, Z72 specifications

Land Pride is a recognized leader in the manufacturing of high-quality outdoor equipment, particularly known for their commercial mowers. Among their lineup, models like the ZXT54, ZT60, Z52, Z44, and ZT72 stand out for their commitment to performance, durability, and ease of use. These zero-turn mowers are designed to tackle a variety of mowing tasks, making them ideal for both residential and commercial applications.

The Land Pride ZXT54 model features a 54-inch cutting deck, which provides ample width for efficient mowing. Its powerful engine, designed for reliability and performance, ensures that grass can be cut cleanly and quickly, even in challenging conditions. Users appreciate the intuitive controls that allow for precise maneuvering, making it easy to navigate around obstacles like trees and flower beds. The ZXT54 also includes features such as a comfortable seat and ergonomic handle grips, enhancing operator comfort during extended use.

Moving to the ZT60, this model takes it a step further with a 60-inch cutting deck. This increased size makes it ideal for large lawns or commercial properties, allowing more area to be covered in less time. The ZT60 is equipped with advanced mowing technology that ensures an even cut and a clean finish. An adjustable cutting height gives users the flexibility to adapt to different grass types and growth conditions.

The Z52 model is another solid option for users looking for a balance between power and maneuverability. With a 52-inch cutting deck, this model is favored for its agility in tighter spaces while still providing a robust mowing performance. The Z52 boasts some of the latest technological advancements, including a heavy-duty chassis and an efficient engine that prolongs work time and reduces wear.

For smaller properties, the Z44 model shines with its 44-inch deck, making it perfect for navigating narrow spaces without compromising on cutting performance. Its compact size does not sacrifice power, as it is outfitted with a capable engine that can handle various grass types while providing a reliable performance.

Finally, the ZT72 model, with its impressive 72-inch cutting deck, is engineered specifically for extensive commercial use. It is built to withstand demanding conditions, featuring heavy-duty components that ensure longevity. The ZT72 also includes advanced features like an enhanced mulching option and a robust suspension system, providing a smooth ride over uneven terrain.

In summary, the Land Pride ZXT54, ZT60, Z52, Z44, and ZT72 models each offer unique features tailored to meet the varying needs of users. Whether for residential use or commercial applications, these mowers deliver power, efficiency, and unmatched comfort, ensuring that mowing tasks are completed effectively and with ease.