Land Pride Z52 , Z60, Z72 manual Fuel System, Engine Oil and Filter, Fuel Filter

Page 37

Land Pride

Section 4 Maintenance and Lubrication

1.Fill the filter element with clean system oil. Smear a light coating of oil on upper surface of rubber seal.

2.Install the filter element on base. Tighten the oil filter by hand until the filter seal makes contact with the filter head, then tighten an additional 3/4” turn with an oil filter wrench. DO NOT OVERTIGHTEN.

3.Start mower engine and let run at approximately 2/3 throttle for a few minutes to work any trapped air out of the system before engaging the steering control lever.

4.Stop the engine and check the filter and connections for leaks.

5.Check the hydraulic reservoir for specified oil level. Add clean oil as necessary.

Clean or replace hydraulic reservoir cap annually. Cap may be cleaned by dipping in or flushing with cleaning solvent. Follow manufacturer’s instructions and warnings for application of solvent type selected.

NOTE: The hydraulic pumps are equipped with bypass valves. For more information refer to Operation section, “Moving Mower with Stalled

Fuel System

!WARNING!

Observe usual fuel handling precautions; do not smoke while refueling, do not fill tank with engine running or while engine is hot, allow engine to cool before storing machine inside a building, keep fuel away from open flame or spark and store machine away from open flame or spark if there is fuel in the tank. Read and observe safety precautions at front of this manual.

The fuel tanks are located in the mower’s fenders. (See Figure 4-6)Total capacity for the fuel tanks is 12 U.S. gallons.

Use regular unleaded gasoline with an octane rating of 87 or higher.

Refer to Figure 4-7.The fuel filter is installed in the fuel line between fuel tanks and engine fuel pump on the front side of the engine. Replace filter annually or after every 500 hours of operation, whichever occurs first.

Fuel Filter

Fuel Filter

19071

 

Figure 4-7

 

When replacing the fuel filter, check the fuel line hoses for any cracks or leaks. Replace as needed.

Engine Oil and Filter

Refer to Figure 4-8:

Check engine oil daily and after every 4 hours of operation. Crankcase dipstick and oil filler tube are located at the rear of the machine. Mower must be sitting level when checking oil. Refer to engine manual and maintenance schedule for oil recommendation and capacities.

Change the engine oil and filter after the first 5 hours of operation, per the engine manufacturer’s recommendations after that. If mower is being operated in extremely dirty conditions, then it is recommended oil be changed more frequently.

The oil drain and oil filter are located at the rear of the engine.

Fuel Tank

19071

Figure 4-6

 

03/11/03

Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M

35

Image 37
Contents Accu-Z Table of Contents Keep Riders Off Machinery Be Aware of Signal WordsFor Your Protection Shutdown and StorageSafety at All Times Practice Safe MaintenanceWear Protective Equipment Prepare for EmergenciesAvoid High Pressure Fluids Hazard 838-303C Important Safety Information838-399C 838-307C 838-308C 838-310CApplication Using This ManualOwner Assistance IntroductionRemote Air Cleaner Assembly Control Lever and Seat AssemblyAssembly and Set-Up Optional Equipment Assemblies Remote Air Cleaner AssemblyControl Lever Extensions Mower Deck Preparation Accu-Vac AssemblyBlower Drive Belt Blower, Pulley and Pulley Cover AssemblyBagger Assembly Bagger Assembly Controls Ignition SwitchOperation Throttle ControlControl Levers Blade Engagement SwitchDeck Height Deck Lift Locking Pin Control LeversInstrumentation Safety Start Interlock SystemEngine Starting Hour MeterFront of mower Faces This Direction Moving Mower with Stalled EngineOperating Suggestions Driving the MowerSteering To Stop or Decrease SpeedMower Deck Operation Operating Instructions Torque Values AdjustmentsSteering Linkage Control Lever Park Brake SlotJam Nut Control Lever Neutral AdjustmentStop Control Lever Control Lever Stops Reverse Spring AdjustmentTop Nylock Nut Reverse Spring Nylock Nut LinkageControl Lever Adjustment Park Brake AdjustmentSteering Dampener Steering Dampener Upper Control Lever Cap Screw LowerControl Lever Park Brake Slot Outside Edge Travel Slot Front Brake Link Right SideBy-Pass Valve Jam Nut Brake Linkage TurnbuckleDeck Drive Belt Adjustment Hydraulic Pump Belt AdjustmentEngine RPM Setting Deck Leveling and Height AdjustmentDeck Level Adjustments Stop Handle Height Adjusting BlocksDeck Lift Threaded Rod Nut Nut Chain Deck Lift Threaded Rod Foot Pedal Nut Nut Chain Bolt Adjuster Jam Nut HardwareLift Block Deck Lift Rod Assist Springs Height Adjusting Stop Plate Deck Cutting Height AdjustmentAnti-Scalp Rollers Anti-Scalp Rollers Adjusting HolesTop View Deck Top View Bottom View Maintenance and LubricationMaintenance Schedule Refer to Tire Inflation Chart MaintenanceTires Torque ValuesHour Meter BatteryLubrication Electrical System Hydraulic System Access to Engine and Hydraulic PumpsSeat Platform Seat Platform Catch Control Lever Hydraulic Reservoir Hydraulic FilterEngine Oil and Filter Fuel SystemFuel Filter Engine Air Filter Improper InstallationEngine Oil Filler Tube Oil Filter Drain Plug Over ServicingGeneral Engine Maintenance Engine Air Filter Service ProcedureDamaged Filter, Seals or Canister Incorrect Air Filter ElementMower Blade Maintenance Belt ReplacementMower Blade Removal Lift Jack OptionNew Season Preparation Preparation of Engine for StorageSpecifications and Capacities Indicators Safety FeaturesWeight Kit Parking52, 60 or 72 Cutting width Features and BenefitsTroubleshooting Appendix Tire Inflation ChartTire Inflation PSIWarranty Corporate Office P.O. Box Salina, Kansas 67402-5060 USA
Related manuals
Manual 6 pages 11.76 Kb

Z60, Z52, Z52 , Z60, Z72 specifications

Land Pride is a recognized leader in the manufacturing of high-quality outdoor equipment, particularly known for their commercial mowers. Among their lineup, models like the ZXT54, ZT60, Z52, Z44, and ZT72 stand out for their commitment to performance, durability, and ease of use. These zero-turn mowers are designed to tackle a variety of mowing tasks, making them ideal for both residential and commercial applications.

The Land Pride ZXT54 model features a 54-inch cutting deck, which provides ample width for efficient mowing. Its powerful engine, designed for reliability and performance, ensures that grass can be cut cleanly and quickly, even in challenging conditions. Users appreciate the intuitive controls that allow for precise maneuvering, making it easy to navigate around obstacles like trees and flower beds. The ZXT54 also includes features such as a comfortable seat and ergonomic handle grips, enhancing operator comfort during extended use.

Moving to the ZT60, this model takes it a step further with a 60-inch cutting deck. This increased size makes it ideal for large lawns or commercial properties, allowing more area to be covered in less time. The ZT60 is equipped with advanced mowing technology that ensures an even cut and a clean finish. An adjustable cutting height gives users the flexibility to adapt to different grass types and growth conditions.

The Z52 model is another solid option for users looking for a balance between power and maneuverability. With a 52-inch cutting deck, this model is favored for its agility in tighter spaces while still providing a robust mowing performance. The Z52 boasts some of the latest technological advancements, including a heavy-duty chassis and an efficient engine that prolongs work time and reduces wear.

For smaller properties, the Z44 model shines with its 44-inch deck, making it perfect for navigating narrow spaces without compromising on cutting performance. Its compact size does not sacrifice power, as it is outfitted with a capable engine that can handle various grass types while providing a reliable performance.

Finally, the ZT72 model, with its impressive 72-inch cutting deck, is engineered specifically for extensive commercial use. It is built to withstand demanding conditions, featuring heavy-duty components that ensure longevity. The ZT72 also includes advanced features like an enhanced mulching option and a robust suspension system, providing a smooth ride over uneven terrain.

In summary, the Land Pride ZXT54, ZT60, Z52, Z44, and ZT72 models each offer unique features tailored to meet the varying needs of users. Whether for residential use or commercial applications, these mowers deliver power, efficiency, and unmatched comfort, ensuring that mowing tasks are completed effectively and with ease.