Jonsered FC2145W, BC2145 Adjusting the harness and clearing saw, Standard harness, Vector harness

Page 16

ASSEMBLY

Adjusting the harness and clearing saw

WARNING! When using a clearing saw it

!must always be hooked securely to the harness. Otherwise you will be unable to control the clearing saw safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.

Standard harness

Safety release

At the front is an easily accessible, quick release. Use this if the engine catches ﬁre or in any other emergency situation that requires you to free yourself from the machine and harness.

Spreading the load on your shoulders

A well-adjusted harness and machine makes work much easier. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.

Correct height

1Forestry clearing

The machine should be supported in a harness when forestry clearing so that the cutting equipment is angled slightly forwards in relation to the ground. Adjust the height using the strap on the harness for the support hook.

2Grass clearing

The machine should be supported in a harness when grass clearing so that the cutting equipment is parallel to the ground.

Vector harness

Safety release

Push down the red release lever to release the machine from the harness.

Adjusting the harness

1 Tighten the hip strap so that it sits securely.

2Tighten the chest strap under your left arm so that it ﬁts closely around your body.

3Adjust the shoulder strap to distribute the load evenly across your shoulders. Press downwards on the suspension hook to load the harness.

16 – English

Image 16

Contents Operator’s manual EPA Symbols KEY to SymbolsCome closer than 15 metres Contents Introduction Dear customerWhat is WHAT? What is what on the clearing saw? BCDecompression valve FC 2145 S, FC 2145 W General Safety Precautions Personal protective equipmentStop switch Machine′s safety equipmentThrottle lock Cutting attachment guard Vibration damping systemQuick release MufﬂerLocking nut Cutting equipmentLocking screw Cutting equipment Sharpening grass cutters and grass bladesSharpening the saw blade General rulesTrimmer head Assembly Assembling the handlebar and throttleTransport position, handlebar FC 2145, FC 2145 S, FC 2145 WAssembling the cutting equipment Fitting the blade guard and saw bladeFitting other guards and cutting attachments Fitting the trimmer guard and trimmer head Trimmy SIIStandard harness Adjusting the harness and clearing sawVector harness Correct balance Fuel Handling Fuel safetyFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping Cold engineStopping StartingHeated handles Basic safety rules Working TechniquesGeneral working instructions ABC of clearingForestry clearing using a saw blade Working methodsGrass clearing using a grass blade Brush cutting with a saw bladeGrass trimming with a trimmer head TrimmingCutting ClearingSweeping Maintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorSetting procedure without a load Blade can be used Setting procedure with a load Trimmer head should be usedAdjusting the start throttle speed BC MufﬂerCooling system Proceed as followsAir ﬁlter Bevel gearDrive shaft Spark plugTemperature 0C 32F or colder Winter useMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Federal Emission Control Warranty Statement Your Warranty Rights and ObligationsPoly Trim 095-.130 Clic 35-50 NMPage Mm 9,0 m Mm 7,5 m Mm 6,0 m 15 cm 10 m 10 cm 15 cm Clic 1150102-95 ´z+R*=¶5`¨ ´z+R*=¶5`¨