Jonsered BC2145, FC2145W manual Fueling, Mixing

Page 19

FUEL HANDLING

Mixing

•Always mix the gasoline and oil in a clean container intended for fuel.

•Always start by ﬁlling half the amount of the gasoline to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of gasoline.

•Mix (shake) the fuel mixture thoroughly before ﬁlling the machine’s fuel tank.

•Do not mix more than one month’s supply of fuel at a time.

•If the machine is not used for some time the fuel tank should be emptied and cleaned.

WARNING! The catalytic converter mufﬂer

!gets very hot during and after use. This also applies during idling. Be aware of the ﬁre hazard, especially when working near ﬂammable substances and/or vapours.

Fueling

WARNING! Taking the following precautions,

!will lessen the risk of ﬁre:

Do not smoke or place hot objects near fuel.

Always shut off the engine before refuelling.

Always stop the engine and let it cool for a few minutes before refuelling.

When refuelling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refuelling.

Always move the machine away from the refuelling area before starting.

•Clean the area around the fuel cap. Contamination in the tank can cause operating problems.

•Ensure that the fuel is well mixed by shaking the container before ﬁlling the tank.

English – 19

Image 19

Contents Operator’s manual EPA Symbols KEY to SymbolsCome closer than 15 metres Contents Dear customer IntroductionWhat is what on the clearing saw? BC What is WHAT?Decompression valve FC 2145 S, FC 2145 W Personal protective equipment General Safety PrecautionsStop switch Machine′s safety equipmentThrottle lock Mufﬂer Cutting attachment guardVibration damping system Quick releaseLocking nut Cutting equipmentLocking screw General rules Cutting equipmentSharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head FC 2145, FC 2145 S, FC 2145 W AssemblyAssembling the handlebar and throttle Transport position, handlebarFitting the blade guard and saw blade Assembling the cutting equipmentFitting the trimmer guard and trimmer head Trimmy SII Fitting other guards and cutting attachmentsStandard harness Adjusting the harness and clearing sawVector harness Correct balance Fuel Handling Fuel safetyFuel Mixing FuelingCold engine Starting and StoppingCheck before starting Starting and stoppingStopping StartingHeated handles ABC of clearing Basic safety rulesWorking Techniques General working instructionsWorking methods Forestry clearing using a saw bladeTrimming Grass clearing using a grass bladeBrush cutting with a saw blade Grass trimming with a trimmer headCutting ClearingSweeping Carburetor MaintenanceSetting procedure with a load Trimmer head should be used Fine adjustment of the idle speed TCorrectly adjusted carburetor Setting procedure without a load Blade can be usedProceed as follows Adjusting the start throttle speed BCMufﬂer Cooling systemSpark plug Air ﬁlterBevel gear Drive shaftWinter use Temperature 0C 32F or colderMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Federal Emission Control Warranty StatementPoly Trim Clic 35-50 NM 095-.130Page Mm 9,0 m Mm 7,5 m Mm 6,0 m 15 cm 10 m 10 cm 15 cm Clic 1150102-95 ´z+R*=¶5`¨ ´z+R*=¶5`¨