HTC LZC5225 / 965879601 manual Roll bar and safety belt, Before Starting, Starting the Engine

OPERATION

Roll bar and safety belt

Operate the unit with the roll bar in the raised and locked position and use the seat belt. There is no rollover protection when the roll bar is down. If it is necessary to lower roll bar, do not wear the seat belt. Raise the roll bar as soon as clearance permits.

WARNING!

The seat belt must be used when the roll bar is in upright position.

Before Starting

•Read the sections “Safety Instructions” and “Controls” before starting the machine.

•Perform the daily maintenance before starting (see Maintenance Schedule in the Maintenance section).

•Check that there is sufficient fuel in the fuel tank.

•Adjust the seat to the desired position.

•The following conditions must be fulfilled before the engine can be started:

•The driver must be seated on the seat.

•The blade switch for engaging the mower blades must be depressed.

•The parking brake must be on.

•Both steering controls must be in the locked (outer) neutral position.

8011-464

Roll bar in upright position

8011-527

Start conditions

Starting the Engine

1. Sit on the seat.

2. Raise the mower deck by pulling the lifting lever backward to the locked position (transport position).

3. Activate the parking brake.

8011-753

Raise the mower deck

Husqvarna - 27