HTC LZC6130 / 965879801, LZ30 / 968999776 Checking the V-belts, Deck belt, To replace deck belt

Page 44

maintenance

Checking the V-belts

Check every 100 hours of operation. Check for severe cracking and large nicks.

NOTE: The belt will show some small cracks in normal operation.

The belts are not adjustable. Replace belts if they begin to slip from wear.

Deck belt

To replace deck belt

Park on a level surface. Apply park brake.

Lower the deck to the lowest cutting position.

Remove foot plate

Remove screws from both the left and right belt shields, and remove shields.

Remove any dirt or grass that may have accumulated around the cutter housings and entire deck surface.

Use a ratchet with a 9/16" socket on the spring idler bolt to relieve the tension on the belt.

Carefully roll the belt over the top of the cutter housing pulleys.

Remove the belt from around the electric clutch on the engine shaft.

Reverse the procedure for installation. See the decal on the top of the deck for belt routing information.

After installation, check the belt for twists.

WARNING!

The idler is spring loaded. Grip the idler arm or ratchet firmly and release slowly.

8011-622

Slackening the belt tensioner

FRONT

8011-580

Belt routing, deck belt

44 - Husqvarna

Image 44
Contents Operator Manual Page Contents English-4 Introduction Good Service Manufacturing NumberSymbols and decals Remove key before General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance For the machine Transport Roll over Protection system Rops Spark ArrestersControls Motion Control Levers Parking Brake Hour meterTracking knob Fuses Blade switchIgnition Switch Refueling Fuel shut off valve Seat adjustment leverSeat Lock Mower Deck Lifting Lever Choke controlThrottle control Cutting height lift pedal Pump release valvesSteering OperationTraining Starting the Engine Roll bar and safety beltBefore Starting Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Return to run position To remove cables, reverse order Weak BatteryJumper Cables Running Mower deck’s gauge wheels should be evenly adjustedEnsure that no one is near mower when engaging blade switch Operating on Hills Stopping the EngineMowing Tips Moving by Hand Maintenance Maintenance Battery Replacing batterySafety System Ignition SystemChoke Cable Engine Cooling Air IntakeThrottle Cable Air filter housing and filter Air FilterEngine Oil Cooler Fuel Filter Fuel Pump Air FilterTo replace deck belt Checking the V-beltsDeck belt Pump belt Tire PressuresBlade Replacement Cutter BladesAdjusting the Mower Deck Adjusting Cutting HeightCleaning Use protective glasses when cleaning and washingRemoval and installation of caster wheel Caster WheelsLubrication Lubrication ScheduleLubricating the Cables Shaft Bushings and LinkageFollowing the Lubrication Schedule Hydraulic System, Oil LevelEngine Oil Changing the Engine OilChecking Oil Level Oil Recommendations Oil TypeMower Deck Height Adjuster Throttle and Choke Cables, Lever BearingsFront Wheel Mount Front Wheel BearingsOil Filter Steering Control ShaftsMower Deck Struts Troubleshooting guide Problem CauseTroubleshooting guide Winter Storage ServiceStorage Wiring Diagram Transmission Technical DataLZC5225 LZC5227 Engine Dimension LZC5225 LZC5227 FrameLZC6130 LZ30 Engine LZC6130 LZ30 Frame Accessories Torque SpecificationsStandard Hardware Metric Standard HardwareUSA requirements CE requirementsWarranty Limited WarrantyAction Date, mtr reading, stamp, sign Service JournalDelivery Service After the First 5-8 Hours Hour Service Service Journal Service Journal Service Journal At Least Once Each Year Action Page 115 138927 R01 06/01/09