HTC LZC5225 / 965879601, LZ30 / 968999776 Steering Control Shafts, Mower Deck Struts, Oil Filter

LUBRICATION

Steering Control Shafts

Tip the driver’s seat.

Lubricate with a grease gun, one zerk for each steering control shaft, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

Mower Deck Struts

Lubricate with a grease gun, one zerk for each strut, until the grease is forced out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

8011-578

Lubricating the steering control shafts

8011-577-1

Lubricating struts

Oil Filter

1. Drain the engine oil in accordance with the work description under the heading “Engine Oil/Change Engine Oil”.

2. Remove the oil filter. If necessary, use a filter remover.

3. Wipe new, clean engine oil onto the seal for the new filter.

4. Mount the filter by hand with a ¾ turn.

5. Run the engine warm, then check that there are no leaks around the oil filter seal.

6. Check the oil level in the engine, top up if
necessary. The oil filter holds 0.2 qt. (0.2 liters) of
	8011-745
oil.
	Changing the oil filter

Husqvarna - 55