HTC LZ30 / 968999776, LZC6130 / 965879801 manual Air Filter, Air filter housing and filter

Page 41

maintenance

Air Filter

If the engine seems weak or runs unevenly, the air filter may be clogged. If running with a dirty air filter, the spark plugs can become fouled.

For this reason, it is important to replace the air filter regularly (see the heading Maintenance Schedule for the proper service interval).

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before servicing.

Dust cap

Check the dust cap every day by pressing the rubber valve with two fingers to let out the dirt.

IMPORTANT INFORMATION

Operating the engine with loose or damaged air cleaner components could allow unfiltered air into the engine causing premature wear and failure.

8011-447

Pressing the rubber valve

Air filter housing and filter

Remove the end cover of the air filter housing by unhooking the two retaining clips at each side.

IMPORTANT INFORMATION

Do not use compressed air to clean the air filter.

Filter should be assembled dry and not be oiled.

8011-448

Removing the end cover

Husqvarna - 41

Image 41
Contents Operator Manual Page Contents English-4 Introduction Manufacturing Number Good ServiceSymbols and decals Remove key before General Operation SafetySafety Instructions Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance For the machine Transport Spark Arresters Roll over Protection system RopsControls Motion Control Levers Parking Brake Hour meterTracking knob Fuses Blade switchIgnition Switch Refueling Fuel shut off valve Seat adjustment leverSeat Lock Mower Deck Lifting Lever Choke controlThrottle control Pump release valves Cutting height lift pedalSteering OperationTraining Starting the Engine Roll bar and safety beltBefore Starting Depress the control for disengaging the mower deck Press in and turn the ignition key to the start position Return to run position To remove cables, reverse order Weak BatteryJumper Cables Running Mower deck’s gauge wheels should be evenly adjustedEnsure that no one is near mower when engaging blade switch Stopping the Engine Operating on HillsMowing Tips Moving by Hand Maintenance Maintenance Replacing battery BatteryIgnition System Safety SystemChoke Cable Engine Cooling Air IntakeThrottle Cable Air Filter Air filter housing and filterEngine Oil Cooler Fuel Pump Air Filter Fuel FilterTo replace deck belt Checking the V-beltsDeck belt Tire Pressures Pump beltCutter Blades Blade ReplacementAdjusting Cutting Height Adjusting the Mower DeckUse protective glasses when cleaning and washing CleaningRemoval and installation of caster wheel Caster WheelsLubrication Schedule LubricationShaft Bushings and Linkage Lubricating the CablesFollowing the Lubrication Schedule Hydraulic System, Oil LevelChanging the Engine Oil Engine OilChecking Oil Level Oil Type Oil RecommendationsThrottle and Choke Cables, Lever Bearings Mower Deck Height AdjusterFront Wheel Mount Front Wheel BearingsOil Filter Steering Control ShaftsMower Deck Struts Problem Cause Troubleshooting guideTroubleshooting guide Winter Storage ServiceStorage Wiring Diagram Transmission Technical DataLZC5225 LZC5227 Engine LZC5225 LZC5227 Frame DimensionLZC6130 LZ30 Engine LZC6130 LZ30 Frame Torque Specifications AccessoriesStandard Hardware Metric Standard HardwareCE requirements USA requirementsLimited Warranty WarrantyAction Date, mtr reading, stamp, sign Service JournalDelivery Service After the First 5-8 Hours Hour Service Service Journal Service Journal Service Journal At Least Once Each Year Action Page 115 138927 R01 06/01/09