Guardian Technologies 02010-2, 04164-3 owner manual ‹ 2.6.1 Mufflers and Spark Arrestors

Page 33

Section 2 – Installation

‹2.6.1 MUFFLERS AND SPARK ARRESTORS

This muffler meets code and standard requirements of the U.S. Forest Service. Use only mufflers and parts approved by the manufacturer. Any person(s) installing an unapproved muffler, or an unapproved exhaust system part, or modifying an exhaust system in any way that might cause a hazard, is liable for any damage, injury or warranty expense that might be caused by such unapproved installation or modi- fication.

Failure to provide and maintain a spark arrestor may be in violation of the law. If this generator is used on any forest covered, brush covered or grass covered unimproved land, a spark arrestor must be installed. The vehicle owner or operator must maintain this device in good condition. In the state of California, the preceding is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.

‹2.6.2 TYPE OF EXHAUST SYSTEM

Two types of exhaust systems for these generators are available from the manufacturer. They include the following:

•“Out-the-bottom” exhaust system dimensions are 15/16” O.D., model 9742.

•“Out-the-side” exhaust system dimensions are 1- 1/4” O.D., 18 gauge, model 4172.

NOTE:

No matter what type of exhaust kit best fits the recreational vehicle, the mounting base has open- ings for either “bottom-out” or “side-out” exhaust systems. Use the cover plate provided with the generator to cover the opening NOT used.

Recreational Vehicle Generator

•If there is any possibility of the tailpipe or muffler being damaged, protect these damage-prone areas by means of a protective device (such as a skid bar).

•Install the generator exhaust system according to safe automotive practices.

•Use enough exhaust system hangers to prevent any part of the system from being dislocated.

•Use exhaust system parts recommended by the manufacturer. Using unapproved exhaust mufflers and exhaust system parts is the responsibility of the person(s) installing such unauthorized parts.

•Do not terminate the exhaust system under any opening, window or vent that can be opened or is not permanently sealed from the vehicle interior.

•Exhaust piping must be large enough to prevent excessive back pressure on the generator engine.

•Never tee the generator engine exhaust pipe into the vehicle engine exhaust piping. This causes excessive back pressure on the generator engine. Also, water from one engine can damage the other engine.

•Plan exhaust system installation carefully. Comply with all applicable codes, standards and regula- tions.

2.7ELECTRICAL CONNECTIONS

Be sure to read the "Generator AC Connection System" section.

The following general rules apply to electrical connec- tions in a recreational vehicle:

•Qualified electricians who are familiar with appli- cable codes, standards and regulations should install electrical wiring.

•The wiring should comply with codes, standards and regulations. The National Electrical Code (NFPA 70), and state and local codes apply.

‹2.6.3 EXHAUST SYSTEM SAFETY

•Maintain a clearance of at least 3 inches (76 mm) between exhaust system parts and any combus- tible material (such as wood, felt, cotton, organic fibers or other like material). If the 3-inch (76 mm) clearance cannot be maintained, locate, insulate or shield the exhaust part(s) so that the temperature of any combustible material is not raised more than 117° F (65° C) above the ambient air tem- perature.

•Extend the exhaust system at least 1 inch (25 mm) past the outer edge of the vehicle. Do not terminate the exhaust system under the vehicle.

•Terminate the exhaust tailpipe such that exhaust gases will not be drawn back into the generator compartment and recirculated.

•Switches and circuit breakers should be of a type approved for use in recreational vehicles and must be mounted and installed to prevent damage from road shock.

•Wiring must be of adequate size, have approved insulative qualities and be properly supported.

•Conduit and wire openings into the generator com- partment (if used) must be vapor-sealed to prevent entry of flammable, explosive or poisonous gases into the vehicle.

‹2.7.1 ELECTRICAL JUNCTION BOX

Install an approved, square electrical junction box with a blank cover on the interior or exterior wall of the area planned for installation of the generator (NOT on the generator). Route the generator's AC output leads into this junction box through approved flexible conduit. This is the point of first termination for generator AC output leads.

31

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Air-cooled Recreational Vehicle Generators Introduction Authorized Service Dealer LocationInside Front Cover Part II Installation Instructions Warning   Electrical Hazards  Model Generator IdentificationSpecifications SafetyGenerator Applicability Generator AC Connection System‹ 1.5.3 Fuel Consumption ‹ 1.5.2 Optional Propane Fuel System‹ 1.5.4 Engine OIL Requirements ‹ 1.5.6 GeneratorGenerator Control Panel Optional Remote START/STOP PanelAutomatic Choke Gasoline only Starting the Generator Before Starting the EngineSUMMER/WINTER Heat Riser System Stopping the Generator‹ 2.7.1 Letting the Engine Stabilize ‹ 2.9.2 High Temperature Switch ‹ 2.9. LOW OIL Pressure SwitchProtection Systems ‹ 2.8.1 do not Overload the GeneratorAdditional Information Checking the Engine OIL Level‹ 2.10.2 Operation in High Grass or Brush Maintaining the Engine AIR Cleaner ‹ 3.3.1 Cleaning the Foam PrecleanerChanging the Engine OIL AND/OR OIL Filter Checking the Engine Spark Plug Clean AIR IntakeBattery Maintenance Cleaning the GeneratorFuel Filter Gasoline only Spark Arrestor Muffler‹ 3.13.1 Removal from Service OUT of Service ProcedureDrive Belt Exercising the Generator‹ 3.13.2 Return to Service Part  General Hazards   Fire Hazards  Equipment Description Purpose and Scope ManualGenerator Engine Operating Speed Standards Booklets0F1127 Location and Support ‹ 2.1.1 Generator Location‹ 2.1.2 Generator Support ‹ 2.1.4 Generator Restraint Generator Compartments‹ 2.2.2 Compartment Construction ‹ 2.2.1 Compartment Size‹ 2.2.4 Acoustics ‹ 2.2.3 Sound Insulating MaterialsTypical Noise Abatement ‹ 2.2.5 Compartment Floor CutoutsCooling and Ventilating AIR ‹ 2.3.1 Generator Airflow‹ 2.3.2 Cooling AIR Inlet Openings ‹ 2.3.4 Testing the Installation Gasoline Fuel System‹ 2.3.3 Compensating for Restrictions LP GAS Fuel System ‹ 2.4.2 Generator Fuel Supply Line‹ 2.5.1 Parts not Included in Fuel System ‹ 2.5.2 Some Important Considerations ‹ 2.5.3 Vapor Withdrawal‹ 2.5.5 Gaseous Carburetion ‹ 2.5.6 Fuel Supply Lines Exhaust System‹ 2.5.7 Excess Flow Valve ‹ 2.5.8 Leakage Tests‹ 2.6.1 Mufflers and Spark Arrestors ‹ 2.6.3 Exhaust System Safety‹ 2.6.2 Type of Exhaust System ‹ 2.7.1 Electrical Junction BOX‹ 2.7.3 Generator AC Connections ‹ 2.7.2 Wiring‹ 2.7.7 Ground Fault Circuit Interrupters ‹ 2.7.6 Power Supply CordOptional Accessories Battery InstallationTesting Under Load Post Installation TestsBefore Initial START-UP Initial StartInstallation Checklist Problem Cause Correction Troubleshooting GuideElectrical Data Electrical Data Exploded Views and Parts Lists Description Exploded Views and Parts Lists QTY Description Exploded Views and Parts Lists Description QTY Exploded Views and Parts Lists SCROLL, Flywheel Exploded Views and Parts Lists Ring SET, Piston DIA Exploded Views and Parts Lists MANIFOLD, Intake Your Warranty Rights and Obligations MANUFACTURER’S Emission Control System Warranty CoveragePURCHASER’S/OWNER’S Warranty Responsibilities Emission Related Parts Include the Following Emission Control System WarrantyWarranty Schedule CONSUMER/PERSONAL Applications

02010-2, 04164-3 specifications

Guardian Technologies has made a significant impact in the air purification industry with its range of innovative products, particularly the models 02010-2 and 04164-3. These air purifiers are designed to enhance indoor air quality by leveraging advanced technologies, making them popular choices for both home and office environments.

The Guardian Technologies 02010-2 is an impressive model known for its portable design and effective purification capabilities. It features a 3-in-1 air cleaning system that includes a HEPA filter, a charcoal filter, and a UV-C light. The HEPA filter is essential for capturing allergens such as pollen, dust mites, and pet dander, making it ideal for allergy sufferers. The charcoal filter helps eliminate odors, capturing smoke and volatile organic compounds, while the UV-C light helps reduce germs and bacteria, ensuring a cleaner atmosphere.

This model is compact, allowing it to fit seamlessly into small spaces, while still providing powerful purification performance. With a whisper-quiet operation, it can be used in bedrooms or workspaces without causing disruption. Additionally, it features an adjustable fan speed, enabling users to customize the airflow according to their preference, along with an energy-efficient design that helps reduce power consumption.

On the other hand, the Guardian Technologies 04164-3 introduces a more advanced air purification system with similar foundational features but enhances the user experience with added functionalities. This model typically incorporates a combination of a HEPA filter and a UV-C light as well, but it often boasts smart capabilities. These may include an air quality sensor that helps monitor particulate levels in real-time, automatically adjusting the purification level when needed. This intelligent feature ensures that the air quality remains at optimal levels without requiring constant manual adjustments.

Both models prioritize user convenience, sporting features like filter replacement indicators, ensuring timely maintenance of the purification system. They are designed for ease of use and portability, allowing consumers to move them effortlessly from room to room.

In summary, Guardian Technologies’ models 02010-2 and 04164-3 stand out in the air purifier market due to their advanced filtration systems, ease of use, and smart technologies. These air purifiers are key investments for anyone looking to improve their indoor air quality effectively.
Top Page Image Contents