Marantz SR9600 manual Bass Peak Level, Level with the or cursor button

ENGLISH

2-4 BASS PEAK LEVEL

1. Select “2. SPEAKER SETUP” from the MAIN

MENU.

2. Select “BASS PEAK LEVEL” with theor cursor buttons.

3. Press the OK/ENTER button to enter the selection.

B A S S P E A K L E V E L

B A S S P E A K T E S T : S T A R T

V O L U M E L E V E L : + 1 8 . 0 d B

‖‖‖‖‖‖‖‖‖‖‖‖‖‖�■‖‖‖‖‖�

	E N T E R
R E T U R N	E X I T

With Dolby Digital and DTS, not only the LFE (Low Frequency Effects), but also the bass of all channels can be heard from the subwoofer or large speakers. This procedure prevents these speakers from becoming too loud and creating an unbalanced sound. Since the sound is output at a loud volume, perform this operation carefully.

Note:

•If your system does not include a subwoofer, this setting will set the bass peak level for your front speakers.

TEST SIGNAL: Press theorbutton. “START” is displayed and a bass test tone is generated from the speaker which was designated for bass signal output during setup. There will be no audible sound yet because the master volume is set to minimum automatically.

VOLUME LEVEL: Adjust the bass test tone output level up until the bass begins to distort or you reach the maximum

level with the or cursor button.

ENTER: Press the OK button, “ENTER” will blink and the bass peak test tone will no longer be generated. The bass peak limit level for your system has now been memorized.

After you complete this portion of the setup, move the cursor to “RETURN” with , , and cursor buttons and press OK/ENTER button to go to the 2. SPKR SETUP menu.

Notes:

•Each time the subwoofer level is changed, perform the bass peak level setup and correct the setting.

•The bass peak level is not available in Pure Direct and Source Direct mode.

•The selected value is displayed in the volume column before the test signal starts.

40