Marantz SR9600 manual Sorting Preset Stations, Name Input of the Preset Station, → Blank → a UP →

ENGLISH	CLEARING STORED PRESET STATIONS
	You can remove preset stations from the memory
	using the following procedure.

2.	3.
	wed Jun 01	4:40pm
	2/2 Tuner 1
	Tuner 1 : Key/RDS
	2.	3.

1. Recall the preset number to be cleared with the method described in “RECALLING A PRESET STATION”.

2. Press the MEMORY button on the front panel or tap the Memo on the remote control unit.

3. The stored preset number blinks in the display for 5 seconds. While blinking, press the CLEAR button on the front panel or tap the CLR on the remote control unit.

4. “xx CLEAR” appears on the display to indicate that the specified preset number has been cleared.

Note:

•To clear all stored preset stations, press and hold the CLEAR and the F/P buttons for two seconds.

SORTING PRESET STATIONS

If you have stations memorized, and there is a gap in the sequential order:

e.g., the stations are stored as follows

1)87.1 MHz

2)93.1 MHz

3)94.7 MHz

10) 105.9 MHz

(notice there are no stations programmed for presets for 4-9), you can have pre set 10 become preset 4:

To sort the numbers, press and hold the MEMORY and the F/P buttons.

“PRESET SORT” will appear on the display and sorting will be done.

NAME INPUT OF THE PRESET STATION

This function allows the name of each preset channel to be entered using alphanumeric characters.

Before inputting names, you need to store preset stations with the preset memory operation.

4.5. 2. 5. 6. 4.

wed Jun 01		4:40pm
2/2	Tuner 1

Tuner 1 : Key/RDS

2.4.

1. Recall the desired preset number with the method described in “RECALLING A PRESET STATION”.

2. Press the MEMORY button on the front panel or press the Memo on the remote for more than 3 seconds.

3. The leftmost column of the station name indicator flashes, indicating the character entry ready status.

4. When press the cursor / buttons on the front panel or the cursor / buttons are pressed on the remote control unit alphabetic and numeric characters will be displayed in the following order:

A → B → C ...Z → 1 → 2 → 3..... 0 → – → + → /

→(Blank) → A UP →

←DOWN

Numeric keypad Display

1A → B → C → 1 → A

2D → E → F → 2 → D

3G → H → I → 3 → G

4J → K → L → 4 → J

5M → N → O → 5 → M

6P → Q → R → 6 → P

7S → T → U → 7 → S

8V → W → X → 8 → V

9Y → Z → space → 9 → Y

0– → + → / → 0

To erase the character, press the CLEAR button or tap the CLR on the remote control unit.

5. After selecting the first character to be entered, press the MEMORY button on the front panel or press the OK / ENTER button.

The entry in this column is fixed and the next column starts to flash. Fill the next column using the same method.

To move back and forth between the characters, rotate the GYRO TUNING dial or press or cursor buttons on the remote control unit.

Note:

Unused columns should be filled by entering blanks.

6. To save the name, press the MEMORY button or the OK button on the remote control unit for

more than 2 seconds.

60