Filter Cycle Start Time

2003 Sarena Bay™

Export Owner’s Manual

Button in the same manner as the hour number. When the desired number is displayed, push the LIGHT Button to accept the selection and change the flashing number to a flashing AM or PM indicator. Adjust the indicator with the UP or DOWN Buttons. After reaching the correct time, push the PROGRAM Button to set the time and exit the time setting mode. You will then be prompted to set the filter start time.

After setting the time-of-day, the top line of the Digital Display Window will read “SET FILTER CYCLE TIME”. Push the UP or DOWN Buttons in the same manner as setting the clock to select the time you want your filter cycle to start. When your desired filter cycle start time is set in the display, push the PROGRAM Button to continue. The pre-set factory default is 12:00 p.m. to 1:00 p.m. repeating every 12 hours unless the number of filter cycles per day has been changed.

Keep in mind that you will later be prompted to set the filter cycle duration and the number of filter cycles. Be sure to keep this in mind when programming your filter cycle start time.

Note

During a filter cycle, the bottom left of the Digital Display Window will read “SPA FILTERING”. During the filter cycle, JETS 1 will activate, the first 5 minutes at high speed and the remainder of the filter cycle time at low speed. JETS 2 will also activate for 1 minute on high speed and then turn off.

Filter Cycle Duration

After setting the filter cycle start time, the top line of the Digital Display Window will read “SET CYCLE DURATION”. Push the UP or DOWN Buttons to toggle between 10, 20, 30, 40, 50, or 60 minutes. The filter cycle will be at low speed. When your desired filter cycle length appears in the Digital Display Window, push the PROGRAM Button to select it. The pre-set factory default is 20 minutes.

Number of Filter Cycles

After setting the length of the filter cycle, you will be prompted to set the number of filter cycles. The top line of the Digital Display Window will read “SET # OF CYCLES”. Push the UP or DOWN Button to toggle between 1, 2, 3, or 4 cycles per day. When your desired number of cycles appears on the Digital Display Window, push the PROGRAM Button to select it. The pre-set factory default is 1 cycles per day.

Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot climates.

Caution

Pump Run Time

After setting the number of filter cycles, the top line of the Digital Display Window will read “SET PUMP RUN TIME”. Push the UP or DOWN Button to toggle between 30, 45 and 60 minutes. This sets the length of time the pump will run when a jets Button is pushed. For example, if you choose 45 minutes, when you push a jets Button, the pump will run for 45 minutes before shutting down automatically. When your desired pump run time appears on the Digital Display Window push the PROGRAM Button to select it. The pre-set factory default is 30 minutes.